Network Management

Hi,I have an issue with HUM 1.2.1. I have deleted a device in Common Services, Device Management. The problem is that there was a poller configured with this device in HUM. I am now unable deleting the poller.

Hi,On a fresh installed LMS 4.0 (Win2008 Std 64-bit) the discovery exclude filter seems not to work as expectedGlobal seed device configured is 172.30.50.10ip address exclude filter is set to172.16.125.*172.17.125.*172.18.125.*172.20.125.*172.22.125....

I am trying to configure a router as a primary DNS server for our remote locations.  Does anybody have example config that I can look at to see how to configure it?  Also I will need to to forward the DNS if it cannot resolve it, is that possible?Tha...

Hi ,I have a Cisco Work Server (LMS 2.6 Version ) in which syslog.log file is growing like anything.Earlier it use to grow around 500MB to 1GB Per day.Since last one week its growing around 6 to 7 Gb per day.I am moving the syslog file through Logrot...

Is it possible with LMS 4 to roll out a VRF across several devices taking into account the unique RD value per device. I would like to use the loopback of the device that is having the config pushed to as the unique value i.eloopback0ip address 1.1.1...

Is there a way, via LMS, to locate the serial number of the original device in a situation like below?Original device OE-612 - OID = 1.3.6.1.4.1.9.1.777New device OE-674 - OID = 1.3.6.1.4.1.9.1.957 (note, hostname & IP was changed, so identity was up...

Hi,,We are installing device package for switch Cat2960. But we get below error message when trying to install the same. WARNING :  Cat2960(6.1):Consistency check failed for base package SharedDcmaIOS When trying to updgrade the SharedDcmaIOS to high...

HiLMS 3.2 RME 4.3I can't choose the device in RME, this device has the same configuration like others, place in the same group in ACS,I have tried remove and add again ,nevertheless  nothing happened.Please see the attached file.Marek

In regards to the syslog database repository in RME, Ciscoworks LMS v3.2, is there a way to push the collected syslog data to a 3rd party syslog analysis collector (SAC)? Is this even supported by Ciscoworks LMS v3.2?

Hi all,I hope you are great. I have a cu with:LMS 2.6on windowsMy Cu wants to change his LMS instalation from the C: partition to a new partition that he is going to add to the server.The only way I think of doing this is by:1. making a backup2. Unin...