Network Management

But when I try to CW says the device is not in ACS and it is the ACS server that we use for all the other devices.Is this even possible.

I work for a network performance team and we were asked to monitor the CPU Utilization for a Cisco 7613. It was thought (by Management) that turing on SNMP would cause the CPU to be over utilized. We usually poll the device via SNMP to gather this in...

Hello, I wonder if anyone can help me, we have just had CiscoWorks installed however this morning we have a strange occurrence where the syslog, config and inventory information is missing from all the devices.  Usually when we go into Device Center ...

Hello,This is my first time to install LMS3.2. I successfully installed the software but I don't know what is the next procedure and I don't know how to add devices. Please, How can I add devices to the LMS.thank you,

Hi,I am using Cisco works LMS 3.2. In Cisco Works Topological View, The device which are connect to each other through GRE tunnel are showingas standalone in Topological View. While checking in the router CDP neighbour that devices are showing in cdp...

I cannot launch Topology Services in Campus Manger.When I start it it shows messge, that i need to restart browser.I used to restart my computer, brouser, but I see same message:Any body know, how to fix it???

I am running LMS 3.2 and Campus Manager 5.2.1.  My data collection in Campus  Manger for my devices does not complete and runs indefinitely.  It has been hung in the "running" state for the past week and will not complete.  I only way I found to get ...

Hi All,I am trying to upgrade the application image on my NAM-2 Module on the  version 3.6(1a-patch3) to version 4.1(1), I am getting this error:ERROR: Application installation has failed. View the upgrade log for detailsI have successfully upgrade m...

Hi,under"Campus User Tracking - Aministration - Acquisition - Configure Subnet Acquisition"Then I have the window with "Perform subnet based acquisition", there is the list with "Available Subnets"1.     From where are coming these subnets?2.     Whe...

hi does anyone know lms3.1 can support nexus?there are two n7k switches deployment with VDC function and four n5k connecting to these n7k through VPC linein CM(version 5.1.4) n7k showed up no connection between these nexus switches and n5k are placed...

Hi Guys,Looking in /var/adm/CSCOpx/log/cda.logcom.cisco.nm.rmeng.inventory.cda.CDAReportGen,getCDAErrorReportDataK = 0 Value = nbltun07K = 1 Value = OKK = 2 Value = No Value To TestK = 3 Value = Credentials not verified.K = 4 Value = No Value To Test...

Is there a way to add the /allow-feature-upgrade flag when pushing .tar images to switches? I had several that failed due to feature set and had to manually upgrade them. Thanks for any help!