Network Management

Hi,I cannot configure port-security from the ChasisView component of LMS,on a WS-C2960-48TT-S switch. When I select "Port Security..." from the"Category" combobox, I get this error message:Can not Configure Port Security Because Dynamic PortI have up...

All,Is there a way to configure SNMP to send traps when a route is no more in the route table?Thanks

We are trying to setup a backup server for our primary Ciscoworks server to get redundancy . We setup the new server and restored the backup on the redundant server and is working fine. However when we click on any of the installed modules say RME , ...

We have some Cisco 2950G-24 EI switches which we have added on our Ciscoworks LMS 2.6 . To do the end host tracking when we try to configure the SNMP Context Commands , the Cisco switch IOS does not support .SNMP Command : snmp-server group xxx v3 au...

Is there a way to change the value markers on HUM graphs?  10Gb/s is much easier to read than 10000000000.  or at least throw in commas...

Hi,I have been attempting a restore using the restorebackup.pl script but it was repeatedly failing 70% of the way through the RME restore.I discovered that the script was changing the directory permissions for /var and /var/adm from root:sys 755 to ...

Hello,when i create a Netshow job,it is always gives me failure status but when i click on the JOB ID to see workorder and then when i click failure it show me the command output.pls suggest .Thanks

Hi,I have an issue deploying a policy with QPM; The policy I am deploying gets stuck on the "in progress" state and never deploys properly. Looking at the CLI of the router I can see some of the policy commands have been entered from QPM, but the job...

Is there a document that gives a better technical explanation of the discovery process? Thedocumentation I've found so far is fairly superficial.I'm testing discovery with a new LMS 3.2 installation and so far it seems like I will have to enter every...