Network Management

HiIn our DFM Alerts and Activities I only get alerts for a few devices only , for others there does not appear any messages. In teh DFM device table I can see all the devices . In the Fault History I get all the messages.Need help in configuring the ...

I want to view switchport uptime/downtime, is it possible to do so on CW? If so, please telle me how.

Dear All, have any one faced issue of slowness after integrating LMS3.1 with ACS4.2. I dont know how can I resolve this issue. Is there any patch to resolve it...Any kind of help will be very helpful.

I'm trying to run a report that will tell me wich switch ports are not configured for 802.1x.  Anyone has any idea how this could be done?I'm not very familiar with ciscoworks so any help is good!  Thanks

Hi,We have a mixture of ATM, E3 and OC3 circuits connecting to our MPLS provider. My question is regarding the QoS policy configuration applied and its calculation in relation to the bandwidth of the interfaces. For example if we have a site with 3 E...

Guys, I am not familiar with TCL or EEM yet, but i need a script that will shut down port 7/43 on my 4507.Basically i have an application that can log in via SSH to my core, and only execute one command from enable mode. I need that command to shut d...

Hi Team,I Have a LMS 3.1 on Solaris 10, I have a some problems, from the origin DFM. When I try Backup this say me :[Mon Dec 14 12:39:12 2009]  ERROR(969): Fatal error: Could not connect to engine 'dfmFhEng' on 'dfmFhDb' in Bulk mode. Check user id a...

I have snmp credentials for routers and switches.Under Device and Credentials > Device Discovery > Discovery Settings I have only 1 option to choose, either routers or switches.How do I set multiple snmp credentials on CW?thanks

After the discovery, my DCR dcontains multiple ip address for a single device.How do I setup CS so that it grab only one IP address for each device?

Hello,The SysLog purge job in RME has recently started failing and I'm not sure why - It has run OK for over a month but started failing on Friday last week??I've search the forums and have found that there was a bug whereby more than one SysLogDefau...

I'm trying to run multi service port report for Cisco 7606 runing 122-33.SRCR1 image and I get the following error:INVREP0060: None of the selected device(s) are multi-service port capable. Select multi-service port supported devices to generate the ...

We're running LMS 3.1.  Whenever I try to telnet to any device I get a message "Application Not Found".  What application is it trying to open and how do I change it?