HelloIn an MPLS multicast environment we have some Cisco 7606 NPE routers. From one of them (POI) I se this HighQueueDropRate in DFM:Name ValueEvent_Description HighQueueDropRateComponent ...
Hello,LMS3.1, when 20 or more lines of config are deployed through NetConfig over SSH job stays in running state. If job has less of 20 lines everything is OK.Is this CSCsw39641 ? End of job log is in att.Thanks,Mladen
Hi friend,One of our customer's is experiencing Software distribution job failure, the old logs in job folder doesn't point to any particular cause.We have verified the Device credentials and snmpwalk. both are successful.Off late, on retrying the al...
Hello,I want to configure Cisco EnergyWise on my network. I have PCs, IP phones and Cisco APs. I get tested and managing the APs and IP phones because are PoE devices, but not the PCs, I've read that requires additional software that will be availabl...
Hi all!I have a problem with official CF from cisco. One day I insert it into my PC card reader and format. Before that day the CF works perfectly but now the router say:Flash card inserted in flash. Reading filesystem on the device...Wait for the co...
I've got a TAC case already opened on this, but if anyone knows how I can get CiscoWorks to do this it would be greatly appreciated.Simply put, I would like the Netacs appliance to appear as all the other devices I have within Ciscoworks. Of course ...
I set the RME Job Purge policies so none of the RME jobs are supposed to be kept after 180 days. For example, Credential Verification Jobs are set to be kept only for the last 30 days.Credential Verification JobsEnabled301195 Dec 17 2009 17:50:00Dail...
Hello all, I'm trying to plan a mass ios upgrade to switches in our network using ciscoworks rme software distribution. I've tested all distribution method(by devides[basic,advnaced], image, remote staging) but it seems like I cannot really specif...
How do you remove devices from "Devices Not Configured in ACS"?CW picked up these devices. Ive restarted daemon process and cleared dcr table but its still there, where is the data store and how do I get rid of it?Thanks in advance
Ive been reading CW student guide, but it doesnt tell you much about tracking voip phones.I can track user PCs but not voip phones. How do I enable voip phone tracking on CW?Thanks
Hello,With lms3.1, from device center the first SNMP walk is OK.When we try to do another snmp-walk either on the same device, either on another device , we recieve this error message:RegardsMichel Misonnetype Exception report message description The...
I'm soliciting input on any additional updates/patches to apply after upgrading to LMS 3.2. The following quartet are the only ones I find so far:rme4_3_1_sol.zipcwcm5_2_1_sol.zip cwcs33-sol-CSCtc38080.tarcwcs33-sol-CSCsy14799.tar The first t...
