I have created a DHCP pool in Cisco 9300 switch and installed 22 Access point to using Wifi.But my issue is, 60 user is connected in access point but dhcp pool is getting full. new user unable connect to wifi.
Forum Posts
NAT and ACLI was using not using ACL in my router before and IP NAT OUTSIDE was configured previously, after I configured ACL in the ethernet interface the user PC cannot to connect to internetCan someone help me explain what are the possible reasons...
Hi guys, so I have 10 IPs to deny them from using the internet during office hours (0900 - 1800) on weekdays. These IPs are from different VLANs. How do I go about configuring them?ip dhcp excluded-address 192.168.20.11ip dhcp excluded-address 192.16...
Hi,I want to transfer files (upgrade bin files) from a linux server to IOS-XE switch using https client.#copy https: flash:Address or name of remote host []? 192.168.0.1Source filename []? http_root/cat9k_lite_iosxe.17.06.03.SPA.binDestination filen...
My college professor has asked me to design a network (on packet tracer) that uses a ASA firewall, as well as a IOS Router Firewall to protect the DMZ. As shown in the screenshot.I'm struggling to understand why we would need a combination of differe...
Resolved! AAA Authentication methods
Hello Guys,I looking for some clarity on AAA Authentication configuration.Problem StatementUsing the configuration below, when i logon with a user account that is valid in the RADIUS server i am able to successfully SSH to the switch, if however i tr...
I am trying to link PI(3.8.1) and WLC(17.3.5a). But everything else connected normally.Only the audit status is displayed as 'not available'. Please tell me how to solve it.
Hi,can anyone help please, i am trying to verify that Cisco have the UKCA certificate to cover the IE3300-8t2s-e product line.Please direct me to the right person, or confirm this with a cert if possible, thank you very much. Ian Mc CullochEolas Tech...
Hey everyone, i have an issue with trying to tftp a file to a switch i have. i have tried direct ethernet connection to the switch, with spanning tree and with out with just an access port. switch was unable to ping PC directly connect but pc could ...
I have a network project to which there is a connection of 2 routers on a Switch and unfortunately I am not managing to establish a communication between the computers of each network. I am using the ospf protocol and serial link connections that I a...
Hola, como cambiar la contraseña de un catalyst de interruptor 6mil, he visto algunos tutoriales pero no logro encontrar el correcto, si alguien a encontrado un video explicativo de calidad y en español, le agradeceria que me lo envie.Saludos.
Hello,Cisco Business Dashboard 2.4.1.20220411 (FINDIT)SG350X-MP24 Firmware Version 2.5.9.13I have a problem where one device is constantly online and I wish he wouldn't show up in Cisco FINDIT in the inventory.And can't delete it because it's online ...
I just installed the Cisco Business 350 Series switch with 12 SFP+ ports and was wondering about the Link Aggregation setup. What I want to do is utilize two ports that will allow me to either double the connection speed of the workstations that I've...
I've been having an issue in Packet tracer while trying to set up NAT on the ASA 5505. When sending a ping the outside router from an inside client, the address is not translated at the ASA, and as such the outgoing source remains the clients private...
HI all,i've DCHP server configured on FW eth1/4 and static IP on router interface Gi0/0.Which configuration i should apply to ROUTER-EDGE in order that PC4 could receive IP address from FW DHCP server? Thanks in advance,MG
