Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 
Labels

Forum Posts

Hi,Is there a way to generate a email Alert for a link latency using IPM modle in LMS ver 3.0.I have configured IP SLA UDP - ECHO on my 3845 Router, but im not getting any traps to DFM/IPM.Please advice.Thanks,Vijay

vijay by Level 1
  • 829 Views
  • 3 replies
  • 0 Helpful votes

We can monitor interface errors from Cisco Works.Can we also monitor specifically CRC errors of devices from Cisco Works

tahseen12 by Level 1
  • 612 Views
  • 1 replies
  • 0 Helpful votes

Hi,I use to take the network backup manually using solar wind TFTP.Backup comprises both the config + IOS images. Till yet i am storing them on my laptops.But in order to increase further security and availability in case i crash / loss my laptop i w...

hiI keep gettnig this error when I run a netconfig job (add commande) in a 3560 switch :ERROR:RME_CDL1031:Transport session to device failed TFTP: Failed on the device. Unable to create a socket to /10.128.31.37 Anyone know what the cause of this err...

bdiouf99 by Level 1
  • 809 Views
  • 4 replies
  • 0 Helpful votes

HiBelow is the error massageMessageFailed to Create Alarm !Cause1)Could be invalid value for some of the entries 2)Could be due to lack of access to the host, invalid SNMP credentials or a busy device.Action1)Verify the values entered for all the ent...

vaibhav-g by Level 1
  • 487 Views
  • 2 replies
  • 0 Helpful votes

Hi to all! I have such issueWhen i open licence page, write: Error communicating with License Server. License Server may be down. Please start the License Server, then refresh the pageBut when i start this process, it still down and write: LicenseSer...

I just installed the latest package for the 7200XVR and the NPE-G1 still shows up on both the front and back views, this isnt correct, it should only show up on the front view - I believe. Is this correct?

Review Cisco Networking for a $25 gift card