I just installed the latest package for the 7200XVR and the NPE-G1 still shows up on both the front and back views, this isnt correct, it should only show up on the front view - I believe. Is this correct?
Hi,This is regarding the new EPC feature available in Cisco routers for packet capture.What is the maximum size of the buffer we can configure for packet capture. ?Will the entire packets be stored or just the headers will be stored. Also if the inte...
HiFailed to create alarms. giving follwing errors.Failed to Create Alarm !Cause1)Could be invalid value for some of the entries 2)Could be due to lack of access to the host, invalid SNMP credentials or a busy device.Action1)Verify the values entered ...
Dear all,from the Document file, the commmand that should be used to upgrade the application image is:upgrade ftp-url [--install]but it doesn't take the last word "install", how to use this command??
I wanted to have Cworks fix a problem for me from CM. It wants to use RME to run the job which is fine. It told me I had to configure the RME server creds. I have a question about some of the fields.RME Server Name: Is this the name of my Cworks serv...
I have a device that I have already configured as a source device for my IPM IPSLA,but each time I try to configure a collector,when I get to the part, I need to select my source device I don`t get to see the device I have configured as my source rou...
Hi allI want to know if there is a way with CSM Netconfig module, to modify the way that Netconfig will answer to the cli prompt that he will receive when applying a job.I remember that in VSM, we can edit a file and tell the VMS's netconfig module t...
I did an update on Solaris 9 from LMS 3.0.1 to LMS 3.1 (server1)The initial discovery runs without any problems; To avoid the steps of adding all users manually I copied the cwpass file from another solaris server running LMS 3.0.1(server2) - but, as...
Is possible to get SampleEmailScript.pl for the automated action for Syslog Analysis. I have no older version of RME, so I cannot copy this script to the newest RME. Thank you.
Ciscoworks is running DFM 2.0.12. The discovery progress for learning devices is stuck at 40% for more than 2 hours. Is there any workaround for this? Thanks.
Hi , We are using the LMS 3.1 . Here we have around 20 numbers of Notification and Email notification group .Recently we have got a complaint like some users ( or IDs) in a particular email group not receiving mails . So we have checked SMTP se...
Hi,Since customer has update RME 4.0.6. He has many devices which config failed partially with this message:Protocol ==> Unknown / Not Applicable CM0056 Config fetch failed for Amberieu Cause: CM0204 Could not create DeviceContext for 653 Cause: CM0...
