Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Bookmark
|
Subscribe
|

“Webinar

 
Labels

Forum Posts

Hi, SirI ask question of SNMP's OID.Could you tell me SNMP's OID when use T1 module on Cisco 2811?PRI1 interface side : NormalOID:Index number:PRI1 interface side: AccidentOID:Index number:Platform:Cisco 2811Module:NM-1CE1T1-PRI Config: card type t...

Hello,Have installed LMS 3.0 on a fresh system. After that I have updated it with the December Update 2007. So now I have DFM 3.0.2.Unfortunately I have some problems with configuring the alerts. I can configure the interfaces and other things I want...

schommarz by Level 1
  • 897 Views
  • 2 replies
  • 0 Helpful votes

Questions:1. We are using IPM and need to send traps to a SNMP collector. We then need to process these traps for our paging/notification system. The traps we have seen to date do not give us much info from IPM. what are some common SNMP trap rec...

I had three problems here:Cisco 6509-E : Problem to retrieve the VLAN database by RME Config Archive Manager.Cisco 7606-S : Problem to be recognised by DFM and RME and CiscoView. Event I check the device update in CS, no update from CCO for 7606-S.DF...

tckoon by Level 1
  • 780 Views
  • 1 replies
  • 0 Helpful votes

Please explain why "sh run" output displays snmp community as <removed>example:"snmp-server community <removed> RO"is this a security feature? if so how is it enabled?or does it mean there is no community string configured?Thanks!

jrabener by Level 1
  • 923 Views
  • 2 replies
  • 0 Helpful votes

Resolved! Unlock NVRAM

Hiin my 2501 password breaking option is disabled.I can break the booting process and go to ROMMON and make the config register in to 0x2142. When I restart I can go to enable mode. But I can't give 'show run' or 'show start' commands.And the moment ...

omal by Level 1
  • 1624 Views
  • 2 replies
  • 0 Helpful votes

CM 5.0 has a feature to report on ports that are up/down ... unused for a period etc.However when I try to generate a report I do not get any results. The data collection has been run (daily) on the switches.Any clues as to why? Thanks

srego4 by Level 2
  • 818 Views
  • 3 replies
  • 0 Helpful votes

Hi,we are in the process of purchasing LMS 3.0. I saw a post that indicated that CiscoWorks was actually receiving Syslog messages. Is this true? Does CW act as a Syslog server or, as my understanding is, only functions as a repository for the messag...

Unanswered Topics

Review Cisco Networking for a $25 gift card