Network Management

HI frenz, I m very new for LMS. I know it is a very silly question. From which tab i can see that particular switches hav or hav not SNMP string. plz tell me.thnx

I have the following abnormal bahaviour of RME (LMS 2.5.1). After discovering and adding devices to DCR, I defined telnet community for each device (I add the user "cwuser" at the ACS and each device use ACS primary authentication). When I try to...

Hi, I am using LMS2.5. can anyone tell me how can i see devices details of my network? I wanna to know that which device has snmp string or which not? sothat i can fill snmp in that device.thanks

when i trying to config. LMS2.5 on window server, the server info shows this reportnetwork.pl*** Default servers are not available*** UnKnown can't find 127.0.0.1: No response from serverwhat it means ? it's shows FAIL no devices is populated in DCR ...

Our BBSM v5.3 is ready and working. I would like to have a copy (image) of complete BBSM server (with Norton Ghost for example) and daily database backup.For total image i know how to do but i am not sure for daily backups.It is important for me to ...

Serial line protocol goes down after 1minute if the other end which is connected to Nortel Passport is locked.This results a delay in redundant linkcoming up..Channelised E1 connectivity between Nortel passport at one location to the cisco 7206 rou...

Hello could you tell me where are saved the vlan.dat file of Catalyst switches?In the RME doc I have just found the following text:Archive and Restore VLAN Configuration FilesFor all Cisco devices that support VLAN configuration such as Catalyst IOSs...

I recently did an upgrade to my ciscoworks server I updated everthing with the cd's that cisco sent me. now when I click on the ciscoworks icon all i get in the web page is server not ready please wait.... its been like that for at least 24 hours. I ...

Hello:I was wondering what Cisco calls this device. I have always known it as a TAD (tech access device). It is basically a modem with multiple serial ports so you can console into your devices if a WAN link fails. Any guidance appreciated.Thanks,...

Does Cisco make a hardware device that you can use for network monitoring? I realize that most people capture data via netflow or snmp and analyze it with various different software programs, but you would think Cisco would have a hardware device ded...

Since a couple of days I'm unable to create any syslog reports. When I run a syslog analyzer standard report as example, all I get is a new page with no records on it.The SyslogAnalyzer and SyslogCollector daemon are both running and when I do a tail...