Network Management

Hi,We have approx. 10 Cisco network equipments (PIX, IDS, ASA, Routers, Cat6, ACS) and we would like to deploy VMS 2.3 and LMS 2.5 to show a live, working demo to our customers.Obviously, we would not recommend a single server installation to our cus...

Hi,i need to check if the ports in my switches are in s.tree portfast state or not. i did try the query 1.3.6.1.4.1.9.5.1.4.1.1.12 and it works fine with my Catos switches but none of my IOS switches answer to this query (cat4500,cat2950,6513).i try ...

After restarting my CiscoWorks server, everything is working great except QoS manager I was able to launch it and start jobs but when I went to view a report it would just give me a red "x". So I restarted the QPM services now I get the following. ...

After replacing a crashed ws-x6k-s2u-msfc2 for a 6513 swich, the new engine cannot be displayed in CiscoView 5.5, but other modules shown correctly. The snmp configuration in not changed and the ios version is c6sup22-jsv-mz.121-11b.EX1.bin.How can w...

If I have a host's MAC address and want to find out its IP address, is there any show command for that or do I need to use an external utility?

hi:i have ACS 3.3 software , and i use it as AAA for Dial up user, i try to make policy as force user as to change there password every a period of time but unfortunatlly didnt succeed i would like to prompt user to change his or her password when h...

Hello, Is there anyway to gather info on power outages, or internal failures from the switch cli? If no, how can I monitor this kind of activity? Any help is greatly appreciated thx.

This may be a silly question, so sorry in advanced, but we have a few 2600XM that are loaded with ACLs and I can no longer save/store the entire configuration files. How do I increase the router's NVRam?

I have a couple of 3745s running a 12.3T train of IOS and I need to monitor the buffer values (hits, misses, total, failures, etc.) via SNMP. I have found that the OLD-CISCO-MEMORY-MIB supports all of the buffer categories except for Very Big Buffer...

Hi,Does anyone happen to know if you can configure Ciscoworks LMS to work in a resilient server config? I know we can do the DEE stuff, but is there any other way of achiving this?Thanks

I've been trying to use Cisco Network Assistant on my Windows XP PC.It never seems to start up, getting stuck at the splash screen saying "Starting Application...". The progress bar gets all the way to 100%, then resets back to zero.Has anyone else ...

I installed Ciscoworks LMS 2.2 successfully, however the server was restarted and since then i have not been able to access the software. I have uninstalled the software and redone the installtion several times but no successPROBLEM:Installed the Cis...

Hello fellow netpros, We currently have CiscoWorks LMS 2.2 installed and sometimes when a netconfig job is run it just get's stuck in the "Job Started" state for no reason. Then I restart the Change Audit deamon under Ciscoworks Admin, run the same j...