Hello, Specialist.Can someone clarify the error message below? This is a Cisco 2901 router. platform-5-ecc_msg a corrected single bit error has occurred in dram at location 0x30197FB0Thank you very much.
Hello, Specialist.Can someone clarify the error message below? This is a Cisco 2901 router. platform-5-ecc_msg a corrected single bit error has occurred in dram at location 0x30197FB0Thank you very much.
Greetings! My client wants to upgrade IOS.Since I havent done any "major version upgrades", I would like to get some advice on this. Cisco 7606-s with 2 SUP modules(RSP720-3C-GE)Current OS Ver. is 12.2(33)SRE1Cisco's suggested IOS version is "15.5.3S...
Is it best to configure the interface you want on the router/switch/fw for ip flow ingress and egress? Should you configure Netflow to be enabled on all interfaces?
I am fairly new to Cisco Prime's Config Templates. I was reading about the "Interface Role" under "Shared Policy Objects" and it looks like something I would definitely like to incorporate into my templates, but I cannot find any examples anywhere o...
Hi, we are in process to upgrade Network bandwidth from 1G to 10G with eliminating single point of failure. Attached diagram for your reference. Point 1 - Earlier there is only one switch (L2) and single port of Router. Now, we use ASR Cluster and S...
Hi,Would really appreciate some assistance in what I 'thought' is a simple task This is what I want to do via TCL / EEM :1.) Enumerate all interfaces on the switch or just query the running config2.) Query each interface config 3.) If the interfac...
Hello Team Currently i use "logging event subif-link-status" on each interface to monitor link up-downs. What is the correct command to use from the global config mode, instead of that from the interface? The point is that i need to see if any sub dr...
Hello, I have a Cisco C2960X and I'm trying to figure out which ports have no devices connected to them so that I can free up space for other devices. When this switch was installed, the installer connected every port on the patch panel to a port ...
Hi,We could not get the mac address table with default snmp configurations, which Object Id should we add and I think we cant add to default view. Should we add a new view? Lastly is there a tool for checking snmp, so I can try to get mac address tab...
where is SN located on FPR4K-NM-8X10G
How can I export ethernet mac address of my all branch switches integrated with my PI 3.4 in one go ? I have 3K+ such devices.
Hi all,I am having trouble configuring Netflow on an IOS XE router through an management interface with a vrf on it. I have used the configuration guide from cisco (https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/fnetflow/configuration/xe-3se/5700/...
We are using PI 3.6 and have to restart it about once or twice a month. ncs status shows the database process has stopped. We have to stop and start PI again. Is there a fix for this?
I have this topology and I need to establish a mpls traffic engineering tunnel between pc1 and pc2 the problem is how I add to my mpls forwarding table the routes learned by bgp
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
Subject | Author | Posted |
---|---|---|
03-13-2024 04:08 AM | ||
03-12-2024 02:34 AM | ||
03-07-2024 08:40 AM | ||
03-07-2024 04:55 AM | ||
02-27-2024 07:22 AM |
User | Count |
---|---|
8 | |
4 | |
3 | |
3 | |
2 |