how does ip igmp work? does this feature disable ports to mulitcast packets when device on port does not respond?
Forum Posts
Can one change/update device address without a delete/reinstall? One can high-lite the address but not otherwise edit same.I don't really want to loose all the 'history' associated with the device when deleted and subsequently replaced with new ipti...
I have been experimenting with the Compliance tool of Cisco Prime for a couple of weeks. I do have a feeling that it is sometimes more difficult than necessary to set up the rules and conditions for the compliance. Aside from that I do have the feeli...
hello anyone can help me about my Cisco aironet AIR-CAP1532I -M-K9 from POE port i cannot access
i have a cisco 3850 switch....i config netflow input and output ...but netflow tool only show ingress flow detail , no show egress flow details, egress only show total flows , and no show flow detail.... do you have any advise???<<<screen shot is the...
Hello, Everyone. I apologize in advance for my ignorance and lack of knowledge as I am new to using access points. Here's my issue... I received a Cisco Air-CAP2702i Access Point from work. Our IT department upgraded equipment and they were going to ...
Why is it that if my service provider has an outage (e.g. a fiber cut) due to damaged or faulty equipment outside my building (beyond my carrier's demarc switch, which my router plugs into), I do not see my CE router's interface status change, my FE/...
Please suggest me some good mib browsersSent from Cisco Technical Support iPhone App
First project out of school is to install new WIFI across the plant. The WAPs need to broadcast 2 SSIDs, one for Plant (static IPs) and one for Comcast (DHCP, handled by firewall). Plant SSID currently works and has full connectivity to plant network...
First time I'm playing around with compliance feature - just using it for basic check of whether a line exists in config or not. I'm at the violation details page and can see the failures. So far so good. Near the top there is a "Devices (Audited/Non...
I have a C2911 router, after upgrade to 15.7, the "access-class xxxx in vrf-also" command seems to be blocking all the access, I have to remove this line so that the telnet/ssh can be working again. I am seeing the same issue on CSR I have one is run...
show logging command on cisco WS-C6513-E didn't show local log, see attachmentany suggestion ???
hi, I have a the EEM script when our ISP fails, it will trigger the failover script and switch over the traffic, plus it sends an email alert notifying the failover occurred, so it is working good, the option that I would like to know if it exist, i...
I was checking if templates exist on switches and if they are compliant to the standard. I was planning to do this with the Compliance Policy tool within Cisco Prime. I didn't check separately if templates exist, i thought that using the "block start...
Cisco Prime Infrastructure 3.4 not taking back in the FTP server.The backup is in running state for the last 2 months.All suggestions will be appreciated.
