Hello,cisco ISR4451-X/K9Is there a way that I can identify routes that are not being used to delete?We have hundreds of routes, and I believe there is a lot of dirt.
Hello All,New to network, got this error message on our backup Job in Prime and not sure if there is a work around or fix for this. Nothing was changed on the backup config so not sure what was the trigger. It does say wrong value. "Exception during ...
Hi everyone,I'm having an issue with a CAT8000V where I am able to create a license smart reservation request, install the license, and everything is fine. After writing, I reload the CAT8000V and check the license status and it is no longer install...
HiEvery now and then we have a router that goes offline because of its 4G module.What we do now is physically go to the router and put in a reload.Is there a way to automatically restart only the 4G module whenever the router detects that it has no m...
We downloaded a new BIOS to router and the tech del old but then new did not fully download. I am getting Unsupported package header version (1868653600)Failed to find bootable image on device bootflash:........autoboot: boot failed, restarting...R...
Hello, I am looking for a way to receive some sort of alert (email preferably) when a Switch on our network receives a local configuration change that overrides its template - putting it into the "Out-of-sync Switches" section, so that we can quickly...
Hello Cisco Community!Today, let's dive into the revolutionary realm of Intent-Based Networking (IBN). As technology continues to advance, the traditional paradigms of network management are evolving, giving rise to innovative approaches like IBN. J...
Hi all, I'm trying to change the log severity and a traffic hits an ACL.I.E the following logging. %FMANFP-6-IPACCESSLOGDP: F0/0: fman_fp_image: list TEST denied icmp 00be.750d.4e80 1.1.1.2 -> 10.10.10.10 (2048/0), 19 packetsI want to increase from 6...
HiCan anybody help me with disable TELNET on swithc cisco 2960s ?I have this config and still telnet works and only show Password required but no set.line con 0
logging synchronous
login local
line vty 0 4
logging synchronous
login local
length ...
Hello,Thank you for reading.Zabbix, version 6.4, will be collecting traps from my 9300 cisco catalyst switch on version 16.6.1.I am having an authentication issues with SNMPv3 utilizing AES 128,192, and 256. However, I am able to authenticate utilizi...
I have read older postings saying this is not supported, but there are hints that it may be in later versions. I have (for example) a 3850 running 16.12.07.ciscoIetfDhcpv4SrvMIBObjects ( 1.3.6.1.4.1.9.10.102.1) appears to have some of the data, incl...
