Hello,We have Lenovo ThinkVision monitors which have USB Type-C one cable solution meaning they also act as docks and connect to laptops, also Lenovo, using USB C.After some time when connected to the monitors our 78xx Cisco phones start experiencing...
Forum Posts
I've got a 2901 ISR with some FXS ports and a UC license and IOS v15.7I just want to set it up to have a small home PBX with each internal phone having an extension that can call internally.Also, CME should connect to a SIP provider registering just ...
Here is what worked for me to get a corperate wallpaper on a 9861NR IP phone. The guide is good but I still had difficulties. Firstly, the image names in the list.xml file adhere strictly to the following format: wallpaper-xxxxx.png, thumbnail-xxxxx....
Resolved! Configure DSPFarm with VCube V8000
Can i configure dspfarm transcode on VCube ?vCuBe#sh inventoryNAME: "Chassis", DESCR: "Cisco Catalyst 8000V Edge Chassis"PID: C8000V , VID: V00 , SN: 94PEYU4VPPHNAME: "module R0", DESCR: "Cisco Catalyst 8000V Edge Route Processor"PID: C8000V , VID: V...
I am using a Cisco router as a Call Manager, and I’ve encountered a problem that I can't seem to find a solution for. Most of the phones have an issue where they disconnect shortly after a call starts, whether it’s an incoming call or a transfer to a...
Hello Team,I need help with call blocking configuration in Cisco Unified Communications Manager.We have an IP phone extension (example: 1001), and we want to block incoming calls from specific numbers so that calls from those numbers should not ring ...
How to get report of all ip phones that are in none status in cucm, and is there a way to know when they went into none status
Hi,We are planning to buy small and cheapest voice router for our SIP Trunk (10 licenses / 10 max PSTN calling or less than that). We have cisco call manger and planning to replace all old mgcp voice gateway routers with new voice routers with sip t...
I'm an not a network guy, understand some but the advanced stuff is above me and I know that. So I ask questions to help my understanding.We would like to block east-west traffic, and I believe that port isolation, private vlans would help with that....
Good Day, we bought our first Cisco ATA 191 but cannot configure it.The device have an ip from the DHCP-Server.After connecting to the web http://x.x.x.x we can login with admin/admin.There is no option to configure anything. We have the tabs "Voice"...
How long does it take for an unregistered IP phone's status to change to 'None'? Based on my research, it should only take 72 hours; however, I noticed that some IP phones still show a status of 'Unregistered' even though they were disconnected 10 da...
We have noticed a few Cisco 840s will not turn on, despite being fully charged.Pressing and holding power button on the top left, whether briefly or holding in for 5-10 seconds and device still won't turn on.Have replaced the battery, left in multi-c...
Hi, We are planning to buy 500 Name user licenses A-FLEX-NUPL-A. Have couple of queries as below1) Only 500 End users can be created or more in CUCM who can do login/logout (extension mobility)? 2) For 1 End user how many IP Phones can be associated?...
Resolved! IP phone Serial numbers
Hello All,We have CUCM 2 clusters and with many IP phones registered, Is there any way to collect the Serial numbers of the Phones?
Hello, Here is an example scenario: Phone A calls ext 4001. On Phone A's display it is showing "Voicemail" as the called information. Instead we want it to show "Hulapi" which is configured on the line of 4001 I think this is happening because ext 40...
