Optics and Optical Networking

Hello,I have a Grandmaster clock for ptp that is also capable of SyncE and the only SFP on it is 1G. On the other side I have a nexus 93180YC-FX3 with not less than 10G interfaces.My problem is that I do not find any 1G SFP module that explicitly sup...

Hello , Is it possible to use Cisco DP04QSDD-HE0 optics between two NCS 540 routers without using OLS (Mux/Demux or Amplifiers) for short (<80–100 km), clean dark fiber link ... i just want to use a single wavelength on this span. Best Regards, M.Jal...

Good morning,I'm falling some equipment and I's trying to get some information on the status of the equipment if they are EOL/EOLP or if they are still supported. NCS 4206, NCS Buss Dist, and ONS15454.

Bonjour,J'ai deux CE cisco C6500 version software 15.2 SY4 connectées aux boucles transmissions, j'ai pas de visibilité sur la partie WDM, mais le port Gi/3 sur CE 2 et le port Gi1/2 sur CE 1 tombe down après une période de fonctionnement, et réstaur...

Hello,In a C9410R chassis, we are planning to buy 2x C9400-LC-24XY line cards.I can see in the specs that there are 20 X 25Gbps ports + 4 X 10Gbps ports.It's not clear, does that means all ports can do the both speed (with SFP25 transceivers for 25Gb...

Good evening! Tell me, is it possible to put different controllers on one shelf?TNC+TNCE

I hope this message finds you well. I would like to inquire about the breakout configuration support on the N9K-X97160YC-EX module running NX-OS version 9.3(11). Specifically, I would like to know if it is possible to configure a 40G or 100G port to ...

Good day! There is a basket 15454-M6 with boards: - SMR-1C-LIC. - 1 quantity - 15454-OTU2. - 4 quantity - Mux 15216-MD-40-ODD-LIC. Tell me what licenses are needed to use 20 dwdm channels

I need a data sheet where can I find this?

I am looking at a DWDM solution that involves the optic DWDM-SFP-10G-C-S.  These optics have a max rate of 10G. My question is does the C9300x series switches support etherchannel/lacp configurations using these optics? A simplified breakdown of what...

Hello,I'm trying to connect N9K-C93180YC-FX3 to Palo Alto PA-1410. I have transceivers listed below:CISCO: SFP-10/25G-CSR-S.PA: PAN-SFP-PLUS-SRIs there a solution to make them work? I'm trying without any results. I'm trying to establish 10 Gbps conn...

We have been using OEM sfps for a long time with C2960 series without a problem but we cuurently switch to a C1000 series switch and apperantly this series does not support the allow-unsupported-transceiver command. Does anybody know  a way to use ot...