Have a Catalyst 4900m switch have 20 copper ports and one sc fiber port and three twin gig sfp. Have lc fiber sfp to go into the converters. the switch reads the sc connector but not the twin gig sfps. is this a software issue or hardware issue.
Hello,I have been trying to configure the Link Fail Alarm on SFP ports for a Cisco CGS2520 (Cisco CGS-2520-16S-8PC).SFP: GLC-FE-100FX-RGD (10-2360-02).I can create a new Alarm Profile and attach it to the Ports that I want to monitor. The update Prof...
Hi,I need your help to know what command Can I use to display the power optics from a interface on a switch WS-4507R+E Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500e-IPBASEK9-M), Version 15.0(2)SG6, RELEASE SOFTWARE (fc1)Technical Su...
Hi all,two queries I cannot find an answer for: 1. is the SFP-10G-LR compatible with the ASR 1002 router? 2. And if so, can it run at 1gig or is it just fixed at 10gig? Thanks, Paul
I have a Cisco 3850 24 that I am trying to connect with a Cisco 6506 E through a WS-6716-10GE module using a x2-10g-lx4 GBIC. From the cisco module compatibility chart the have the same wavelength but i can't get a link light. Are these modules com...
I need to connect SFP+ server with Cisco SFP+ switch. They are very close to each other so I need just 2 meters cable. I can do this using two cables: eitherCisco SFP-10G-AOC2M Active Optical Cable assemblyorCisco SFP-H10GB-CU2M Twinax cable, passive...
Hello,I need to connect a fiber between a WS-X6708-10GE module of a 6500-e chassis to a third-party Firewall. The Firewall has 10G SFP+ SR transceiver. I need to connect the two devices through a 10 Gbps link. I'm not sure if I can connect a GBIC to ...
Hi Everyone...I have a few days testing with the ME-4624 ONT, to provide internet to its LAN. This device is connected to a functional ME 4605 OLT , and the needed route to provide internet to the equipment its already configured and tested. I also c...
I have a switch with all four 10g optical links on a port channel showing -40.0 dBm Optical Receive Power. I believe this means it's not receiving a signal at all. I don't have physical access to the switch nor the device the port channel is connecti...
Dearshave a good dayi have 75 IP camera on a fence, the distance between every two cam is 40 meters.what is the best solution to connect them to the NVRs?
Hi,Is GLC-SX-MM supported in CGS-2520-16S-8PC 100BASE-FX SFP ports ? It's not listed in compatibility table, GLC-SX-MM-RDG is listed as supported on gigabit SFP ports only.
Hi At one of the plant we have C2960S-24TS_L switches are provided with multi mode transceiver but the Optical Cable available at site is single mode Optical fiber. So i procured a single mode transceiver. But I came to know that we have to some con...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: