Other Collaboration Subjects

Hi,Can we have a conference call between two ip phones connected on lan using G711 codec and two ip phones on Wan using G729 codec. I have doubt that who will do the codec conversion can the MCS box do it or do we need to install a router or some dev...

My situation seems related to the following unsolved case: routing rules table corrupting azdave7042 Jun 5, 2002, 2:15am PST I used "option 3" and created eleven CTI route points and eleven "forwarded call"...

I've recently starting working for a new employer who does not currently take advantage of Post Routing. I believe that Post Routing would distribute our calls more efficiently, not to mention, result in lower call wait times, average call times, et...

Hi,I am new to the voice technology. In fact this is my first.My customer has a 3640 at his HO. He plans to buy 1750V for his two remote sites. He also plans to use VoFr. He wants to connect two phones each at the remote sites to his PBX. The PBX is ...

Hi Folks, Just installed a VG200 with 2 port T1. T1 1/0 is going to a Nortel PBX and is set up as AMI, SF, and internal clocking. T1 1/1 is going to a Telco and is set up as AMI, SF, and line clocking. I'm getting slips on T1 1/0. I've swapped t...

Does anyone know if it is possible to integrate CallManager 3.1x with the Avaya Unified Messenger 4.0 platform? How? Any issues?Thanks.

Whats the common phone load in use for the 7960 on 3.2 at the moment?Are people still using P00303020204 or its there a better version released that people are using?TIAGary

I am running CM version 3.1(4b).I have a device profile setup to forward all calls to a 1877 number the call search space for that profiles is set up to allow long distance calls. When I trying calling the device profiles directory number I receive ...

I am getting the above error when trying to run the Unity Configuration wizard. This is a new install of Unity 3.1(4). I have verified the group does exist. Any ideas would be helpful. I have checked all permissions etc.. I have never seen this error...

I'm just starting to test out Attendant Console and am finding that if I try to look up a whole department at a time that I only get 10 people, but if I look up All, then everyone is there. Any idea why?

We use 9 as our outside line button and have recently had a rash of accidental 911 calls. I think it is occurring when people are trying to make a long distance call, they accidentally put in an extra 1 before the area code. They quickly hang-up re...

I want to send reports to an email adress. I get allways the error 10011 System Error: Contact Sys Admin.I config the Mail Server Param as discribe in "CCM Serviceability Guide" without success.Any experience ?I work with CCM 3.2(2c)ThanksMartin

I have installed Unity 3.15 with a pbx link to a Meridian 1 switch. I am able to get into the opening greeting, but the vm will not transfer to another extension, but interview handlers do work. I did notice that in Device manager that Windows does n...

Can any one make some suggestions on dial-peers...I have a T1 PRI and Two CallmanagersI have DID with 570-85xx range but the phone company send only 3 digits so I translate incomming numbers to add the 8.Here is what I have right now.dial-peer voic...

Today I restored the unity server using DiRT and migrated it into my domain (as opposed to in its own domain, where it was previously) using our domain corporate exchange server as the mail store (as opposed to Exchange on the box). Everything worke...