Other Network Architecture Subjects

Please Please Please help. I am pulling my hair out!!!My network configuration is as follows:INTERNET – ROUTER – PIX FIREWALL – ISA SERVER – LANI want to route my SMTP traffic into my exchange server inside my LAN. Please NOTE that all devices are c...

Do you know if it exists a configuration converter from IOS to CatOS (I know the opposite one).Thanks

I have an 3640 router "IOS (tm) 3600 Software (C3640-I-M), Version 12.1(5)T",I use it to interconnect many different other router by using x25 circuit, the problem is when I augment a debit to 2 Mbits the interface is down, but with a 1700 router the...

Can anyone tell me what conditions cause a serial line to report being reset. We have a line problem so I have a good idea of the source of the problem but I am interested in what the interface is missing/receiving to cause this conditionThanksAndy

Dear Sir,What IOS will support the 802.1Q encapsulation on 3745 and 2600 series E1 interfaces? what I found that it only support sde encapsulation?I am running Enterprise plus feature set (C2600-JS-M), Version 12.2(6), on Cisco 2600 series router. At...

I have a problem in the atm interface,loss conectivity intermittent.I throw it thecommand:show dsl interface atmWIC Config Reg2 0x03 Gen bus error on bad ADSL accessInt 0 Enable Reg 0x03 ADSL normal interrupt enabled ADSL e...

Dear all,I write you because when I reload my router 826 (After that I did a write mem)I lost the date and time settings,that I previous set with the command clock set.The config register is 0x2101.Thanks & regards,Igor Fabrizio

Hi, I have one inside interfaece and one outside interface. When I enabled nat in the outside interface as "Ip nat outside" and gave the global command as "ip nat inside source list natlist interface Loopback0 overload" .But I didn't mention in t...

whythis error is coming in the router. What is the solution for this .The error is "Jan 18 06:57:52 GMT: %STANDBY-3-DUPADDR: Duplicate address 10.155.101.3 on Ethernet0/0, sourced by 0040.eff2.75f2"

Recently we were discussing the pending replacement of a few VINA routers which currently terminate our T1's with ciscos. We also have cisco 1721's right now on the inside of the VINA's connected into switches with our other firewalls and such. The...

Hi!does anbody knows how to limit the bandwith that goes in and out of a Fasthernet port in a 3550 switch.In that port we have a Server that shouldn't transmitIP packets (or Eth packets) over 200Kbs

When creating a new VLAN interface on a RSM, will the interface be down/down until a machine is connected to the 5500 and configured for that VLAN?Many thanks,Daniel