Other Network Architecture Subjects

We have a remote loaction connected with two frame relay pvc's. One to an ATM router and one to and IMA router. The IMA and ATM routers are set to load balance the traffic. When doing traceroutes from the remote location we get the following results...

We have ATM subinterface, we set the MTU for this subinetrface to 1528, and we are trying to form an OSPF adjacency between this interface and Ethernet interface on other router. But the adjacency won’t come up because of MTU mismatch (1500 for the E...

Hi,What does it mean standby router is expired.sh standby vlan 31Vlan31 - Group 31 Local state is Active, priority 110, may preempt Hellotime 3 holdtime 10 Next hello sent in 00:00:00.756 Hot standby IP address is 10.2.108.1 configured Active ro...

I am looking for a sample config of a 1601 router using a T1 line?Any help appreciated!

I'm setting up an IGX 8410. Whats the default user ID an password?.When booted, it asks for a user ID and password. These are new units and documentation doesnt indicate any default username and password. Also during the boot process, at a point you ...

We've been displaying a larger number of errors on our Cat2980 can anyone recommened anything to reduce this number?Port Align-Err FCS-Err Xmit-Err Rcv-Err UnderSize----- ---------- ---------- ---------- ---------- 2/1 - ...

Hi All,We have 2 2600 routers.One router has FE IP x.y.z.252 and the other router FE is x.y.z.253.When I try to put the first command for hsrp i.estandby 1 ip x.y.z.254, then following error it shows."address cannot equal interface IP address"Will an...

Hi.When I try to get an Update Upgrade Info from RME/Administration/Software Management I can see a critical error: Upgrade Path Knowledge Base not found.Check the SWIM crm version and kb version input values.Why?Thanks.Andrea.

Greetings to all.I was jsut wondering if I can install two WIC-2Ts in a 2611 with no problems. The unit has 64/16 running enterprise plus IOS. And if so, what is the numbering scheme? I know that one WIC-2T will use Serial 0/0 and 0/1. Would the seco...

Hi,I have got two pairs of windows 2000 Advanced server configured in windows network load balancing in the unicast mode.For each pair of server, the first server is connected to first Cisco 2950 catalyst switch and the second is connected in to seco...

HiI have a 3640 which has got a PRI card for remote users to dial in over ISDN. The service went down on Friday night and the telco provider (in UK) say that the line is fine. Config looks OK, I've reset the router etc but still no joy. On Cisco View...

Does anybody know whether the next release of CiscoWorks will have / allow JRE other than the 1.4.1_02 currently required by Update 1 of the May 2003 packages? Failing that, is there any work around to allow one to use a more recent vintage (say 1.4....

I recently tried to upgrade a 3550-12T from IOS 12.1(8)EA1c to 12.1(20)EA1 using CMS gui. It appeared that the CMS lost contact with the tftp server during the initial phase of the upgrade. Now when I try to upgrade again, I see:.done<DL>Unable to ...