Other Network Architecture Subjects

Hi,I wanna configure my remote site to obtain DHCP addresses from my Main site, through a WAN Link that contains a 3662 and 805.But not the same subnet, I mean: my local network has for example 10.11.12.0/24 and the remote network should have 10.11.1...

The maximum supported number of configured DLCIs in Cisco7507Cisco7507, RSP4, Version 12.1(9), DS-3(HSSI)

Hi,Unable to understand this issue. CPU utilization shoots during specific period. The Show Proc Cpu doesn't indicate any process thats eating up cpu cycles. Have a look.

Dear Sir/Madam,How can I configure the 2950 switch to allow only one specific host to acces this switch via particular port?I used the mac-address-table static 0003.ff19.711d vlan 1 interface FastEthernet0/7The PC with this mac address can only use t...

We need to tie in a new building with about 5 connections to an existing network using a switch (SW5).A cost effective way to do this would be to connect to the furthest switch via fiber. However, this would create 4 switches "daisy chained" together...

Somebody can find out the cw2000 it supports SNMPV3

I am running Ngenius 1.4 and recieve the above error message? Also, is Ngenius deliver any monitoring ability if you do not have a NAM installed?Tahnks in advance

I have a public firewall at site 1 with a private subnet behind it.I have a public router at site 2 with a public firewall with a private subnet behind it.I have a site-to-site vpn between the site 1 firewall and the site 2 router. I currently access...

Hello, I am trying to find out some info on multilink. My company is looking at connecting to a remote site using Multilink. We currently have a 2611XM located at that facility. The plan is to drop a VWIC-2MFT-T1 card into the 2611, order two T1...

I thnik I understand how the ip-helper address works fairly well. However, our DHCP admins now want to add 2nd ip-helper addresses in the routers. I can't seem to find any information on cco about how the routers behaves regarding the 2nd address. Do...

I am seeing output drops on my IMA interface. Does anyone know what a common cause for this problem is?

Hi,I have a problem with my inter-vlan router. It's a 6500 with a SUPII with MSFC/PFC and my network has approximately 600 hosts split into 4 VLANS. I cannot understand that such a high-end switch could be dropping packets, considering that there a...

We are just beginning to add ATM serial WAN connections to our network. I cannot get Campus Manager to discover these new ATM links. Any suggestions??