I will be using Network Load Balancing on two servers using a 6509 with CatOS. I would like to know what configurations will need to be done on the switch.
We are introducing VLANs onto our network and will be using two 6509 switches with 720 supervisor engines to perform the inter-vlan routing. However, as well as IP we also use IPX which will need to be bridged. Other than a document titled 'Underst...
Hello,I'd like to ask the default default admin password of CiscoWorks for Windows ver 6. Its not clearly stated in the docs of the evaluation copy.I tried adding user at WhatsUpGold with all User security settings being check as well as the Map leve...
On a catalyst 4506 (IOS 12.1(19)EW1 ), I try to forward UDP broadcast to a subnet with the global command: "ip forward-protocol udp 4203" and on the VLAN-interface "ip directed-broadcast".Has someone a clue why this doesn't work??
can anybody give me an idea where a problem might possibly be on my setup:USER --> RAS --> LNS --> RADIUSScenario: usernames and passwords are always sent to radius for authentication (this is given).Problem: Radius logs show that there are instances...
Hi, I need to upgrade the IOS of my catalyst 6509. I would like to know the procedures to do it.I have the new version but before installing it I want to know the steps and command to avoid further problems. Can somebody help me to solve this questio...
Hello,I've a problem with an dial in on a 3640 with a NM-4B-S/T= and a NM-30DM= .I can dial in from a PC and it works fine, but when 3 or 4 connections are established sometimes no traffic come back and I've to reconnect and it is then working.Can so...
Hi,I have one Problem in the followig scenario, I hope you can help me:Router 1:Subnet 192.168.80.0/24 (Serial 0 / IP: .1)Subnet 192.168.99.0/24 (Ethernet 0 / IP: .1)Router 2:Subnet 192.168.80.0/24 (Serial 0 / IP: .2)Subnet 192.168.99.0/24 (Ethernet ...
Hi All,After installing MS SBS2003 with two NICs,Router (830) is available, everithings fine, but in IE hangs at "Loading Cisco Router Web Setup. Please Wait..." With my old system I used and configured this Router 1000 times, and had no such problem...
My customer wants to downgrade a 2 Mb connection to 1 Mb. The local PTT doesn't deliver 1 Mb connections.So I have to do something on the routers.As far as I can see I can use rate-limit or GTS (encapsulation is hdlc).Any recommendations ?
Hi there,I have a Cisco/Linksys WAG54G ADSL gateway / router / WiFi G which is working fine, except for one simple thing : I can't connect to the administration page thru a web browser from Linux, while it's working fine from windows.Linksys' support...
Does anybody have any resources for ascertaining a router's CPU utilization during an OSPF convergence? 'show processes cpu | i OSPF' is helpful only as a baseline current view. Is there no resource to ascertain a link-state databse change's impact o...
Hi,this report shows me that the startup config doesn't match the running config. The running config is freshbut the startup shows something older but not the actual startup from the device. An archiv update desn't help. what is wrong ?
