Other Network Architecture Subjects

I have router A with 2 serial frame relays, dlci 101 and 102. I have remote router B with 1 serial frame relay dlci 150. I was planning on moving router B from frame leg #2 dlci 102 to frame leg #1 on dlci 101. Everything is already configured on tel...

If I wanted to do a manual IOS upgrade to a router or switch where would I find the /tftp directory on CW2000. On my LINUX box I have TFTP setup to use /tftp subdirectory.What is the path to get to a source file in the example below if I want to get ...

Erase startup??? - alternative commandDoes anyone know an alternative command to use instead of "erase start".ThanksEK

Does anyone happen to know if Cisco offers hands-on clases on their latest network gear?thanks

Could somebody please reference a source that I could read about the exact definition and possible relationship of the following terms :switching fabric forwarding bandwidth forwarding rate how do these interrelate and how do we calculate them ?I wou...

I have installed CW SNMS at customer site. Everything seems to work fine except retrieving configs from devices. whenever i try to fetch a config, i get status "failed". I checked all the necessary attributes via "check device credentials"; they all ...

Is there a way to unlogg a user from CW2K? I have noticed that once i log off, and then log in under Admin, it still shows my personal login as being logged in still!

Hello,I would like to have an opinion on the following configuration for QoS in a Hybrid Cat6509.This is the first time I am implementing it on a production box. The main idea is control the traffic for a specific server in the network.This configura...

I've got some questions concerning T3 technology that I haven't been able to find a clear answer about anywhere.1) What is the difference between Clear Channel and Channelized? I've heard that Clear Channel (B8ZS? I know what this, is Clear Channel t...

We have a 4506 switch with a supervisor IV engine. I configured an ip address to each VLAN interface in the network, and enabled them with the no shut command. I entered the ip routing command, and setup the default gateway to a cisco router that h...

A co-worker and I are trying to figure out the reason for a particular statement in this example...hoping for some help. This example is the Surf & Sand network merger. Our question has to do with access-list 1. The exact line in question is this:...

Quick question here. When I do a trace that goes through a set of routers configured with HSRP, the first hop come back with a result of:Tracing the route to 10.185.20.75 1 10.186.99.2 4 msec 10.186.99.3 0 msec 10.186.99.2 0 msec 2 * * *N...

Hi,We have to be able to provide the total number of packets and bytes switched by the backplane. I amaware of the show system and show traffic commandsat the cli, but is there a MIB or query that canbe run to give this information? Any pointers wo...

Guys,I have been on the software selection tool that cisco offers but have not been able to find the software I need. Basically I have a 10/100 eth module that isn't being detected at the moment, and the error message suggests that i need an OS upgra...