Other Network Architecture Subjects

All,I need to perform a network audit and I'm confused with what are the best tools?This is mainly a Cisco network (routers, switchs and IP Telephony devices), but with some Nortel and 3Com switchsCan anyone help with that ?thanks in advance,Marco Pe...

we have a depot which links into our main site via a local router. this router points the link to another router finishing with .300 we now need it to point to a router ending in .298 does any one know the command and path to alter the router?

Hi,I am trying to connect to my firewall in order to enable logging for FirewallAnalyzer (www.eiqnetworks.com). The help file says to telent to the firewall and then gives a list of commands, but I havent the slightest idea how to even connect.Thank...

Hi, suppose i have the following scenario :R1 --- P2P link --- R3|X1|R2 --- P2P link --- R4My objective is to do load balancing and redundancy between the 2 P2P links... The remote site has the same setup. X1 has a connection to the LAN.Have thought ...

I config two Vlan on Catalyst3550-EMI,Vlan1 IP Address 10.241.0.1/24Vlan100 IP Address 10.244.0.1/24I hope that vlan1 can access vlan100, but vlan100 cann't access vlan1.Please help me!Thanks

Hi,If you configure a router with multiple ip helper addresses for DNS (for example). Will the router send a DNS request to all ip helper addresses? Or, will the router try the 1st, wait, then 2nd, ...? Thanks.

This is a very unique situation. I have a building with about 120 users on 3 floors. There are 7 wiring closets with 13 cisco 3550 switches. I have updated them all to c3550-i9q3l2-mz.121-20.EA1.In this setting, I have 4 divisions and about 14 pri...

All,I am the defacto cisco admin, although I am just learning. The devlopers came to me earlier and want to set up a test network for several of their servers. I would like to set them up on their own segment (I believe?) where we can control what ...

Dear Friends,I have a query on the Cisco 831 series router. The Cisco 831 series router has 4 10/100 switch port. This router belongs to Ethernet to Ethernet router Category . Now can I connect 4 seperate routers on four 10/100 ports of 831 series ro...

I just received a new 2950C-24 and in the 1st few hours of configuring the switch I lost its' password 4 times. I went through the password recovery procedure from the cisco site. The IOS is C2950-I6QrL2-M 12.1(19)EA1c.

My primary ISP is sprint, from what i can tell the only way to add add'l bandwith is to have the same provider provision a new t1 and the use CEF or multilink for load balancing. Although I'm really not getting 3Mb of BW just two separate 1.5 meg pi...

I configured the router for callback. When the callback is completed, I show user on router and cannot see which user is being connected (the router shows unknown user). Can the router show which user is being connected ?

I have 3 vlans (ID 101~103) enable ip routingip route 0.0.0.0 0.0.0.0 gateC3 defferent gateway at vlan103 gateA,B,C which has static route vlan101,2 gw vlan103 and direct connect to internetFor some reasons I need put vlan101(some-IP) route to...