Other Network Architecture Subjects

I have just upgraded too 12.3(7) on a 3640 and am seeing "access-list logging rate-limited or missed 23 packets" in the logs fairly frequently. This is in a test enviroment without much traffic so I know the router is not heavily loaded. I never saw ...

It seems our router does not support this MIB. So what should we do to make it support this MIB. Basically I am asking how to make a network device support some specific MIB.BTW, this MIB tells the relationship between VLAN and router interface index...

Hi,Tryin to setup a ipv6 testlab with 2 cisco3600 routers(1serial,2ethernet) connected with 2 serial cables with 2 hosts on each side of network.Assigned ipv6 addresses to all needed interfaces and on both sides all works wel exept the rip routing p...

Hi,I need a clarification for my customer on following statement from CCO:The Supervisor engine, the routing engine, and the forwarding enginemodels must be the same on both modules for redundancy to be supported.Is this true for all cases?Does this ...

Hi,if I have an access-list hereaccess-list 101 deny tcp 63.36.9.0 0.0.0.255 any eq 80do I need to apply to interface s0 port?Can you tell me what command syntax to do?thanks again

I have a 3550 switch that is connected to a Catalyst 6509 switch. The ports on both are configured as trunk ports with ISL encapsulation. Both ports are running 100 full duplex. My 3550 is generating a lot of input errors (no output errors) and runts...

Looking for information on the WIC-1ADSL WIC for the following show commands.Sh controller ATM0 and sh DSL int atm0.Have read some Cisco documentation but the white papers doesn't explain the output and what crucial information to look for troublesho...

Hi ,I have a query regarding STP.While going thro the documentation of STP i am not able to understand the TCN BPDU.Will really appericate if somebody can provide me any tips to understand.Rgds,Renu

Is it possible to test VWIC-MFT-E1s back to back for testing ?

I have a server with a DHCP-server running and a DHCP scope.The server is on another location but we need the DHCP here. We have a cisco 828 router and I activated smart relay and dhcp relay information trust all. Also i have put in the command: ip d...

Hello,I am relatively new to network management and therefore struggling with the following to my opinion horrible problems: I use Concord to discover my network topology. When discovering 7000 series routers, Concord discovers different CPUs in the ...

Would be interested to hear from anyone who has installed or knows of CiscoWorks LAN/RWAN in a Sun Cluster, or, if you would recommend not attempting it, please respond.

I have 2 CAT 3524 XL switches trunked together. I have 2 different subnets one on each switch that I want to have our DHCP server give out different address depending on which subnet they come from. I have IP Helper commands on each Vlan pointing to ...

I have 2600 with 4 port ATM IMA and c2600-ik8o3s-mz.122-23.bin IOS. Al four AL LED's on my card are on. What could be the problem? ATM interfaces are down.Thanks!

I have been installaing Cisco WAN Manager 12.0.00 Evaluation copy on a Sun Fire 280R machine with Solaris 8. Installation halt towards the end.Installation Progress bar move till the end & halt.Installation Log message as follows."Adding the user svp...