Other Network Architecture Subjects

Hi,I would like to know, is it possible to run Works2000 in Windows 2003 server environment?All experiences are welcome.Thanks,Peter

Hello all, we currently have 2 3com switches connected over mmf fibre for a distance of approx 1km, my problem is:I have purchased 2 * 2950 switches and 2 * GBIC gigabit fibre module cards (multi mode). I am trying to swap out the current 3com instal...

Is there a way to determine the serial number of an installed SX GBIC on a 4000 and/or a 6000 with7.6(2) code?thanks

c837-k9o3y6-mz.122-8.YN.bin= IP/FW 3DESc837-k9o3sy6-mz.122-8.YN.bin= IP/FW PLUS 3DESI understand the differences between the above IOS and that C837 is the model of the router but does anybody know of a link that provides a breakdown explanation what...

Hello,I´ve installed SNMS 1.0 and the server "freezes" because high What´s up process. Others applications work without problemsThe server passe all Hardware Minimum Requirements:* Pentium IV 1,2G* 1.0 Giga RAM* 20 Giga Hard Disk* Windows 2000 Server...

We have migrated our voice system from multiplexer to VOIP solution. However, there were a lot of errors generated at one of the router (1721) when we attempted to put off the multiplexer and connecting two sites with routers directly. I would like t...

The checks print is intermittently incorrect. The frame that has the check information is different than what was sent but no FCS/CRC errors occur. This occurs intermittently over a low speed WAN (56K) Link only.I tried to duplicate this in our lab...

Hi,Suppose i have a L2 switch and got VLAN100 and VLAN200 configured on it... The switch has got 1 link to the router and the router to internet...I do not want VLAN100 and VLAN200 to communicate. Thus the switchport link i configure as trunk...How a...

I need to change the ip address of the CW2K Server running on Solaris 7, is there a procedure to do it or i just simply change the IP?Thanks in advance

few questions/sanity check regarding atm service modules..T1 | ATM | CBR VC2651xm platformenterprise + feature setIs 4-port ima module the smallest/cheapest module that can be used to terminate a single t1 atm service on a 2600? what application fits...

I need to know how I load the config to a 4506 using tftp

I have two 1760 routers each with a 1DSU T1 WIC card. I want to connect each T1 WIC so as to simulate a serial connection before I put the devices in production. Can anyone tell me the pin out for a RJ48c (if this is what I need) and the commands t...

A bad config register value was put on a 1721 in error. Now I can gain no console access to the router via hyperterminal, whatever the settings. Is there a factory/hardware reset I can do ?