Other Network Architecture Subjects

Hello,cann somone tell me if this config is ok ? both router are Red. connected on 2 ISP 7500 series and on 2 Cisco 535 PIXthanks for helpRouter1#interface FastEthernet0/0 description Connection to ISP ip address 213.60.26.5 255.255.255.224 ip verify...

Greetings,On a 6816 module with DFC3 I see the socket to upgrade the memory to 512. My question is, is there any kind of memory used on a 6816 without a DFC3?-TIA

Can I route IPX on a Cisco 3550 EMI SwitchCan I also bridge OSLAN traffic using the bridge-group command

Hi any help is much appreciated !I have 2x Cisco 3725 routers running 802.1Q trunks to 2x 2950T switch with enhaced switch software.The switches are trunked together to form one logical device.The router trunks have hsrp groups configured on each sub...

Here is my situation: (1) - We have two offices, let's say Office A and Office B. They are connected via a bonded dual T1 dedicated connection. (2) - Each office has its own internet T1 connection.(3) - We have 'newer' Cisco routers connecting the...

Can somebody provide an advise on how to rate a LAN network?I have cisco and HP switches and I have cisco routers 2500, 2600 & 3600.I want to take a base line to prove that I need to upgrade my networkAny help is greatly appreciated

Hi, We have two locations A and B. Location A has two serial interface one to internet and the other to Location B through IPLC Line. In the Router in Location A Nating is done with Serial 0/1 facing the internet as router outside and ethernet as nat...

Please forgive my ignorance, however I've searched past posts, and read the manual, and cannot find an answer.Is it possible for me to be able to manage the port via telnet/ssh/web without having to dedicate a port for Management.Currently I have por...

Can anyone help me out here. I have an old Cat 2900 that has a 9 pin Serial port for the console instead of the standard RJ-45. I have tried various cable configurations but cannot console in. I have searched through the website here but cannot find ...

I'm setting up a WAN w/ 7200's with 3 sites so for. I've set up the links w/ IPSec and I have tunnels between each site. Everything seems to work fine, except I notice that the bandwidth available between sites isn't symmetric - for example if I se...

Hi folksWe have discovered an evolving problem. Our customers - normally small sites with 5 - 25 PC's get their IP config from an DHCP server in an Cisco SOHO router - typically an 831 with IOS 12.2(8) or similary. We also often have an Cisco Catalys...

Can i create 3 VLAN in a layer 2 switch namely VLAN1,VLAN2,VLAN3 and configure in such a way that VLAN1 can communicate with all the other VLAN and other systems that are connected through a non-manageble switch and hubs and no other system in the ne...

Hello all,Can anyone tell me why my iBGP route is not syncronised? Using EIGRP as the IGP, and I can ping my iBGP next hop address?Many thx indeed,KenLDVD1WR54>sh ip route 128.233.0.0Routing entry for 128.233.0.0/16 Known via "bgp 500", distance 20...