I need to disable SNMP Write. I have tried to use " * " in place of default public string, but every time I "save" the change it defaults back to public. Does anyone know how to disable SNMP Write in ANI discovery, or RME?thanks,Vince
I am trying to find a way to monitor CallManager (and Unity, if possible) server statistics such as processor utilization and disk utilization via SNMP. Through another post, I was told that the CISCO-PROCESS-MIB is what I need but it only appears t...
It´s possibly during heavy load periods on a WAN link E1 speed (2.048MB), have a lose adj on ospf (because "dead time expired")??Should I configure some priorization for hello packets?? What´s recommended??At the moment I´m using priority queueing wi...
For Router 3600/3700;What is the difference between E1 and Serial interfaces ?I thought both also meant for leased line connection ?Please help to clarify.TQ
1.Why does not cisco's isis add authentication CLV in SNPDUs,even text authentication has been enable on both area and domain level?2. RouterA-------------------------------RouterB L1L2 L1L2 Enabl...
I have a DHCP pool setup to serve two FastEthernet interfaces, and I need to split it to two pools, one for each interface. Is it possible to do this, and if so, how do I do it?Regards,Spencer D'oro
I have a 2950 running IOS 12.1.13(EA1) with the following config.I have a tacacs+ server setup for authentication for the switch. When I telnet into the switch, it prompts me for username and password which works fine. When i add the authentication f...
Hello,I have an AS/5300 that is used for dialing in and out of a datacenter as a "modem-pool". AS/5300 is also used for dial backup purposes.I need a way to find out which users on my AS/5300 are actually using it. Sh isdn hist command only shows me ...
who can help me to solve the isdn issue that the router cannot construct the isdn call well? the related debug infor is follow:4w0d: ISDN Se2/0:15: event CALL_PROGRESS dsl 04w0d: ISDN Se2/0:15: CALL_PROGRESS: CALL_CONNECTED call id 0x3196, bchan 9, d...
I have got a 828 router that is constantly rebooting, i don't even have chance to get into the config. Is there anyway of resetting it to its factory default settings?? (i have openedd it up and there are some pins inside that could be used to do thi...
I've configured SSH connectivity to my 2600 in the IDS MC, where it was previously working fine using telnet. Once SSH is configured, the telnet connection to the router is dropped, and that's normal, but an SSH session does not begin. With telnet,...
Due to some issues of hardware support, I would need to downgrade from IOS 12.2(14)SX1 to CatOS 8.1.2. Is that possible? Does it exist any document with any explanation about how to do it?Thanks for your help.
I have remote sites with a VPN connection as a primary path and a frame-realy link for backup. The problem is that the Frame-Relay link is not seen as a FS to the VPN Tunnel. I have looked at the following URL:http://www.cisco.com/en/US/tech/tk365/...
Hi FriendsMy Indian office and UK office is connected by a point-to-point dedicated serial leased line.I have backed-up this serial link with an ISDN link between these two offices. Presently, if the primary link fails, the ISDN is triggered from the...
