Other Network Architecture Subjects

Hi all,I am not able to boot IOS from TFTP server instead of flashMy configuration is as follows:1. Cisco 2621 with 12.0(7)T stored in flash2. startup-config: boot system tftp c2600-js-mz.120-7.T <ip_tftp_server>3. TFTP server is Linux RedHat4. The I...

Just want to know if there is somebody ever implement the CNSPE for collecting VoIP data and can share the experience?Thanks,Janto

Hello I am trying to configure my AS5300 access server to authenticate to a certain radius server if our customers dial into a specific dialin number by a aaa dnis map. So far I can dial into this number and the 5300 will send a request to the proper...

Due to international policies, I need to turn off CDP at wan interfaces and I still needing to discover that network, Is there any way to discover the network without using the CDP protocol?

hi folks, I am currently upgrading my backbone to gigabit ethernet over fiber. I just got some new switches. 4000 at the core and 2950's for each floor. 1)We have three floors with about 150 clients total2)we already have two subnets.one for ...

Hi,Recently I tried to upgrade IOS on my 2621XM router but due to timeout it ended that there are three files with similiar filename but with a invalid CheckSum append at the end of the filename.I have only one partition of flash on the router and I ...

We have a 6509 with a 1300w redundant power supply connected to 110V. If our 6509 is Fully populated will one PS be able to keep it up and running or do we need 220v.

I will be setting up 2 Cisco 2600 point to point with a full t1 using the WIC T1 CSU/DSU card to I have to set up FDL (Facilities Data Link)?

I am doing some testing with an application programmer who has an app that dials in from a PC to an AS5300. The PC is using a USR_Sportster modem, and the access server has a single ISDN PRI circuit. Here is the line config for the modem pool we ar...

The router reset, and show the next message System returned to ROM by bus error at PC 0x6055DBB8, address 0x3E3C2F5C. In the output interpreter say that is a problem of memory or IOS, but I changed memory and IOS and the problem continued.If you know...

Hi,I want to explore and impelement the GRE tunnel between two of our offices connected via serial links.Can you please help me out .Provide me some sample configuration.regards

Dear all,I'm not sure if this is the correct forum for this query, but here goes anyway.We are looking at installing 2 x 4507R core swithces. Both units will run 2 x Supervisor engines which will have both GB interfaces connected to each unit (will b...

I just purchased a CABV.35-SS-MT cable and seems what interface card should I use?WIC-1T seems like not fitting.