Please let me know what these error indicate. Users started to lose connectivity when this error was found. Does this indicate a sup failure.regards,shashankpacket on port 7, but it came back on port 12003 May 28 13:25:40 IST +05:30 %SYS-4-P2_WARN: 1...
I am looking to setup syslogging for all my CAT switches. I have setup a server with syslog running on it and it is tested and working. I have setup a single switch as test with the following configuration added:logging "ip address of server"loggin...
Hello,I use a 2600 series router.The first interface is connected to Internet with public @ip (ex : 34.1.1.1) and the second interface in my private network (ex : 192.168.11.0/255.255.255.0).I use NAT between those 2 networks : ip nat pool test 34.1....
I have two Routers 3660 in the network but when I try to look at these devices in CiscoView, the routers go down. This is very curious, I don't know what is happening. When I look at the devices after they reload, only says that "system passed to ROM...
Hello, I would like to execute an automatic action up on receiving a specific Trap or generating a specific DFM alarms.The automatic action should be any executable script (not only send an Email), some thing like wath we do with RME>Syslog Analysis...
I´ve got problems to manage AP350 with cw2000. New package is installed. I can only configure the read community in the AP350, but for communication cw2k needs the write community. What´s tehe problem ??I look forward to your reply,thank you very muc...
I have a HUB 7513 router (vip2-50 card,8 port t1 ima) connected to ATM and Frame Relay Spoke routers.ATM config is point-to-point aal5snap.CDP is not discovering any of these Frame Relay Routers.Is there a problem doing CDP over IMA?Anyone have any i...
Is this possible? The tutorial I have seems based on a 7000 series. I don't have the encapsulation command on the router in the sun-interface. I need it to understand ISL. It is IOS 12.1.Thanks,D
Ok - we just setup a 3550 switch to be our default router and I need some advice as to if i set it up correctly or any gotcha's that i may have missed:as you can see i have the 4 subnets. i do not have a route configured to the other 3 subnet ports ...
I have a config that appears to be 'checked out' in Config Editor, but Config Editor doesn't see this (ie won't list any checked out configs). As a result, I can only open Config in Config Editor as read-only or if I use NetConfig, it complains that ...
Using the com port on an XP machine, to console into an IOS switch, the up arrow to repeat the last command does not work properly. Anybody else have same problem?
I have been asked to propose a PoP for internet access using dialup. The system is supposed to support 210 (7 E1s) concurrent connections.I found that the AS5350 will do but I'm confused which cards or modules to use.Please help !!
