Other Network Architecture Subjects

I have a customer who wishes to use g.shdsl to connect 3 remote sites to a central site. (the carrier has confirmed service availability at the sites)Can anyone please confirm my understanding of this technology by commenting on the following stateme...

Hello, I need Help .. Actually our network is configured as is : One Router 7120 , with ISL encapsulation One Catalyst 3548 , One 3508 and 7 3524 and 3550 .. MY question is . We are very intersted of bying a Cat 4006 with superengine III , but I nee...

I was wondering what the rationale was, behind the "Available Bandwidth" reading when looking at the 'show int s0/0' command. I have DS1 point-to-point ckts hooked up to these three routers, with all 24 channels in use, no MUX or IMUX at all. ESF, ...

how many IP-Interfaces (each with HSRP and all with differnet HSRP-groups) are possible on a 3550?are there only 16 possible (with newest IOS!) ???

Hello !Could you please help us.we are having intermittentent network connection losts with ibm 600e laptops with 3com 3c575c 10/100 pcmcia cards ( with or without docking stations).laptops are windows xp's. switches are 1924 ver V8.01.02 : Sta...

I wish to place Appletalk Workstations on different VLANS on a single routing switch and then router appletalk traffic between the workstations. If I assign a cable-range to each VLAN interface but do not assign any zone information to the switch or ...

There's a descrepancy in the spantree portcost setting between the 2 config files on our cat 5000 taking within a 4 month period. To the best of my knowledge, no one manually changed them. Are they somehow getting auto reset depending on what is plug...

Hi After seeing Unicast flooding due to Asymmetric routing we had to adjust the ARP timeout to match the CAM aging time. Changing the CAM aging time to 144400 seconds solved the problem But when we try to do it other way and decrease ARP timeout as ...

We have to implement a straightforward bridge between two sites. The original site uses ip addresses 197.0.0.1 to 197.0.0.50 (which we can't change as it is under the control of another supplier) with subnet mask of 255.255.255.0. We are re-deploying...

Hi,I would like to find out how does my router built up it best path. From the router itself, what command must i type to check on the following attribute in the bgp path selection . Network Next Hop Metric LocPrf Weight Path*>i...

I have a US Robotics modem connected to a 7200VXR aux port. I dial inand get a connection, but no response.We setup line aux 0 modem inouttransport input allflowcontrol hardwareIs there something I am missing?Just to check the aux port, can we do a d...

Dear Sir!I'm trying to use aux back-to-back in my home lab how configuration below described with rolloved cable:http://cisco.com/warp/public/793/access_dial/auxback.htmlBut in my case (R1/R2) its not work:R1# sh line aux 0..............................

Hello everyone, I'm seeking advise to resolve my findings in Catalyst switch 2950T, The switch appears hang up when i encounter the problem while connected remotely (telnet) further invistigation shows that my uplink and their physical connection in...