Other Network Architecture Subjects

I have Cisco 1601 routers at my branch offices and cisco 2611 and 2610 at the head office. Each branch office is connected to the head office via 64k point to point data line. My problem is that, at my branch office, routers always fail mostly 4 at a...

How much data transmission capacity of "WS-C2924-XL 8MB" switch in terms of 'packets' & 'bytes' ?

Hi alli have 3640 two routerits connected same provider with 2MBlinkpast 8 hours iam getting full traffic even i removed total input trafficiam getting lot of un wanted trafficiam not able to find what could be the reasonhow do i find what is the pr...

I have a Cisco 3640 running IOS 12.1.I am having trouble sending logging messages to teh syslog daemon on a Redhat Linux 7.1 machine.The config on the Cisco is !logging trap debugginglogging facility local5logging ip_addresss_of_linux_machine!and I ...

I'm just starting in the WAN arena and wonder where a data T1 multiplexer usually located? Our data T1 is terminated with a Cisco 1720 router with T1 WIC that has an integrated CSU. That line then goes through to an external DSU, then a Network Inter...

I have Cisco 1601 routers at my branch offices and cisco 2611 and 2610 at the head office. Each branch office is connected to the head office via 64k point to point data line. My problem is that, at my branch office, routers always fail mostly 4 at a...

Hi,Does anybody know where I can find the fact sheet/resouce regarding performance of Cisco router 1700/2600/3600 series with/without VPN module installed ?I would like to weight between setting up router as IPSec 3DES home gateway and VPN 3015 Conce...

I have Cisco 1601 routers at my branch offices and cisco 2611 and 2610 at the head office. Each branch office is connected to the head office via 64k point to point data line. My problem is that, at my branch office, routers always fail mostly 4 at a...

I have a Cisco 2600 with an ip addr of 66.178.47.99 255.255.255.248 configured on ethernet 0/0, while ethernet0/1 has an address of 10.1.180.102 255.255.252.0my problem is that while i can ping a vsat modem with ip address 66.178.47.97 connected to e...

I have 2 networks ... a) 192.168.70.0b) 192.168.71.0One router ethernet interface has been configured --ip address 192.168.70.3 255.255.255.0 ip address 192.168.71.1 255.255.255.0 secondaryAnother router ethernet interface has been configured ...

What could be a possible reason why in a three switch setup-all attached to one router(a 3640) would the first switch pass outgoing traffic better(faster) than the other two. All are set up the same, using the gig uplinks, same default gateway(the ...

What is the procedure for upgrading the boot rom's on a Ciscopro 2522 so that it can run a newer IOS?

when i use ip uplink-redirect, although ACL on interface (subinterface) is operated, but the interface level rate-limit {input\output} command has no function. when the traffic rate >3M, the CPU utility is over 80%. how can i do?