Currenlty I have 18 (6x3) GB ports blades in my Cisco 4006. I require approx 25 GB ports. What I need to know is if the WS-X4418-GB blade can support trunking ( pref the 802.1q encap) on its blocking ports and if the blocking ports can be connected t...
We are in the process of rolling out a new RAS solution utilizing three AS5350 access servers. Our scenario is that when a remote user connects to the access server the access server will go to the DHCP server and get an ip address for that connectio...
I want to connect the two switch together. On the 2948G L3 port I have configured a port such as this interface FastEthernet7 description 2916XL Switch no ip address no ip directed-broadcast duplex full!interface FastEthernet7.1 encapsulation isl 2 n...
We are operating in a large environment and want to make sure we are getting the most out of our servers. Is there a document anywhere in your databases that talks about performance tuning for servers running CW2K? We are operating on Solaris. If ...
we have a problem that when we enable traffic shaping our ip traffic just sits in the queue and then gets dropped Even if there is no vofr traffic and our frame provider says that they see no congestion on their network. vofr and cdp traffic always ...
I am trying to setup enhanced monitoring of all inbound RAS access attempts to avoid intrusion from former employees. I need to capture inbound caller ID on a pri (TELCO can enable this {for a fee}). Also need time stamped user IDs attempted and pa...
An Mcast receiver sends an IGMP join request to receive data for a group. Do Mcast sources use IGMP atall to register a source group to it's RP?This is confusing me :(Many thx in advance if anyone can clear this point up for me.Ken
I have troubles on getting a multilink PPP session working, using a "Xircom Cardbus Ethernet 100 + Modem 56 / ISDN" PCMCIA card.I use a Cisco 7200 as the LNS, where the L2TP tunnel is beeing terminated. On the client side I set up the Xircom card for...
all,I have a sub interface that was inadvertently set to multipoint. When I attempt to change the setting, I get the message below.interface Serial1/0.6 multipointmyrouter(config)#int 1/0.6 point-to-point% Warning: cannot change link typeWhen I trie...
Hi, I am a beginner in the world of routing and router commands. So, please I need your help as much as u can. I have two 256 Kbps ADSL lines to provide internet connection to my organization. They are connected to our Cisco 3640 router via e0/0 an...
Hi there,In chapter 3 of the switch documentation (page 3-2) says that maximum depth of a rack is 32" (81.3 cm). Can you install the switch into a rack ~35" deep?What's the reason for specifying max. depth?TIAGoran
I just upgraded from CiscoWorks for Windows CiscoView v5.1 to v5.3. When I start CiscoView, it asks for the username and password, which by default should be admin and admin. Everything works, but when I click on CiscoView to start the application,...
