Other Network Architecture Subjects

Hi,I have a small question, if i configure multiple Dialer Map in the same dialer if pointing to the same IP, but different number (see hereunder):dialer 1 ..... ..... dialer map ip 99.0.0.1 name atlanta broadcast 5151515151 dialer map ip 99.0.0.1 na...

I have a customer (inexperienced network administrator) has the following stations setup and problems:Host A = 10.1.1.10 /24Host B = 10.1.1.6 /16Host C = 10.1.2.8 /16All above stations are connected to a Cisco Catalyst 2950 switch.Host A can ping to ...

I've searched CCO but I cant find a page showing the complete list of the supported devices in Campus Manager 3.2. Would anyone know if the Catalyst 2950 and 3550 is supported on this release? because these devices are not yet supported on the 3.1 re...

Hi everyone,Does anybody know of a workaround for using MLS on an interface that has an access-list with the established command on an entry?I have read that using the established command stops MLS from working. I currently have an interface that I w...

I need to know if I can install the CW2k 2.0 and the ACS 3.0 on the same Win2k server.

I have a question. I have more then 24 vlans defined in msfc. Most of vlan interfaces have ip helper-address for different server. I’m implementing a NIS broadcast for one vlan by enabling the IP FORWARD PROTOCOL UDP RPC as global command. The proble...

Hi Guys!Very strange thing happening as I see. This bug is in state closed (!!!) So that simply meant that all unnecessary non-RPF traffic on my routers will remain, and I will have high load due to what? What about another IGMP - mroute related ques...

HiIs the Catalyst 2950 layer 3 switch?WS-C2950G-24-EI - this is the part number of the switch.Thanks.

This is a follow-up question on the 4006 S3 topic. There are only 2 options for the supervisor3 of the catalyst4006. Will I be able to configure appletalk using any of these software versions? Im trying to implement VLAN subnetting in the network and...

We have a 3640 router connected to a PBX using an E1 connection with the following configuration:controller E1 3/0 framing NO-CRC4 clock source internal line-termination 75-ohm ds0-group 0 timeslots 1-12 type e&m-i...

I have network that I need to segment using VLANs. My original proposal was to go in with a 2621 router and a 3548 switch. The assumption here was that the 2621 could route between VLANs on the 3548. Can I replace this whole solution with a 3550-E...

I am always having the difficulties in deciding which Cisco router types to use in preparing my proposals to my valuable customers. Anyone know that is there any guide and requirement specs for me to refer to in the router type selection. Please help...

Hello,I try to modify metric with bgp between 2 AS. I use route-map and "set metric 1000", but the metric 1000 is not announced in bgp update. I'm full BGP and i don't do any redistribution between my 2 AS. It seems that metric apply only to routes r...

Hi,Has anyone gotten something like the "nat 0" command on a PIX to work on an MSFC? I'm trying to get specific traffic to pass from an inside interface to an outside interface without being natted.Thanks in Advance,Drew

Ihave a 2501 router. I have configured a Dialer interface and associated dial group but when I configure a dialer map I get a message saying ' a dialer must be selected first'. Any Ideas