Guys/Gals....I have a question as far as design goes. I have to replace equipment at several off site locations. I will be replacing a 3660 with a 7206 vxr and a catalyst 4000 with a 6506/msfc. My question is this. How should I set up the routing...
The documentation (at the URL below) for the BGP route-map action cmd 'set metric-type <blah>' says this command sets the MED value of the matching BGP update to the value of the IGP metric to the "next hop".http://www.cisco.com/univercd/cc/td/doc/pr...
Cisco Catalyst 2924-XL switch, STP supports 64 vlans. What happens when another vlan, say 65, is assigned? Does the 65th vlan operate with out STP? What are some of the issues I need to plan for? Thanks in advance - I don't have a switch to test this...
HiI have the following scenario :Router A is connected through a Frame Relay PVC to a private IP backbone running BGP.Router B is also connected to this private IP backbone. Router A can see router C user LAN through EBGP and vice-versa.Router A is ...
A quick and probably easy question but I have a standard class C private network with static IP's(192.168.12.xxx) of which I have a Cisco 3620 router to allow access from outsite sources. What I have is my network has used up my range and I am out of...
Hi guys,trying to bring up an ISDN interface at 7am and downing it at 7pm everyday. The router is a 2503. We dont want to use interesting traffic to bring up and down the interface (business reasons).Anyone got any ideas as to how this could be achi...
helloi can't find the exactly definition of one switch's caracteristic , that is: transfert rate.for exemple : for the catalyst 2950, we find that it has a backplane of 8,8Gbpsand a transfert rate of : 1,8Mpps (12 ports) ...
Using ospf can I get all internal traffic to use only one of the 2 backbones and all traffic headed out to the internet to only use the other backbone ?Each backbone is connected to my routers. I know I can set the cost for incoming traffic.
I have an external router 7206. I need to connect a dedicated router to it. The dedicated router is in my place but does not belong to us and directly connect to T1 to a specific site. I am using 7206 router to NAT instead of using my firewall. The ...
When the CSU/DSU on the frame-relay side resets the connection does not come back up. The ATM side shows it up but I cannot pass layer 3 traffic. After a shut/no shut on the ATM it comes right back up and passes traffic.Are their any config setting...
FriendsI am maintaining a good number of sites running on OSPF. Recently I have started facing strange problem. My one of the site has got 2 x 2 mbps links. Earleir my both links were working fine . Nowadays one of the link I can't ping from the rout...
Most of the time recently, upload is higher compare to download traffic in my cisco 2610 router connected to 3640 at speed of 64kb e1.Even if ethernet load was disconnected, it remains high.Could any body help me to solve this problem.
I have a 2600 router and 2 networks: 192.168.1.0 & 172.16.1.0. I want to set up a NAT between them. I have configured the 192.168.1.0 as the outside and the 172.16.1.0 as the inside. I have set up my access list and my pool and my source list. Everyt...
Can you help me with a CAR problem. I am running ISL on sub ints of a 3620 & am trying to limit the bandwidth used by each vlan. I have applied CAR input and output on the subints as follows:interface FastEthernet0/0.3 description Customer3 encapsula...
