This is a follow-up to my previous 'slow PAT routing on a 2621"...After many hours of troubleshooting, I have come to the conclusion that my 2621 is not capable of fast-enough PAT routing out one of the 10Mbps interfaces in its installed NM-4E.My pre...
We want each user on the port of Cat1924/Cat2950 on saparate VLAN. These switches are getting aggragated at Cat4000. How many VLANs can Cat4000 can manage if it is used as L2 switch or if it is used as L3 with MSFC? Is it the max. no. of VLANs suppor...
I am finalizing the design of our new corporate network. It will consist of the following:Work Station Access - 3548 XL Switches - 2 per floor (one East / one West) ; total of 14 for seven floors. Each side of a floor will be a separate VLAN (Subne...
We are having problems trying to go from c7200-is-mz.120-2a to c7200-ik9s-mz.122.7a.. We are adding the following boot statement to the config:boot system flash disk0:c7200-ik9s-mz.122-7a.We set our config reg to 0x2002 as the router is remote and we...
HELP PLEASE !!!I'd like to reconfigure our Cisco 4000 Series router in such a way that it would best fit our requirements. I'm trying to access the router through a console port and the following messages appear:System Bootstrap, Verion 5.2(7b) [mkam...
Can anyone tell me the command string that I can use to have our 2620 hand off a DNS server to remote access users that are dialing into the router?Thanks in advance!-Tony
I have 2 4006 switches, and each has a Supervisor III module installed. The appropriate SNMP community strings are set along with logging parameters. I have found that Cisco Works cannot manage the Supervisor III module and Campus Manager cannot ma...
Looking for the Pro's & Con's of disabling VLAN1 on Catalyst switches.Can someone provide a clear explanation as to what REALLY happens and what does not happen when vlan1 is disabled?NOTE: Cisco documentation URL www.cisco.com/warp/public/473/21.htm...
I have a quick question that maybe you can help with. I have an exsisting IPsec config that I want to add NAT to and I was wondering if it is possible to use one of the exsisting 'Extended' access lists as my source list in the ip nat config. I have ...
We have 3 sites, with a 3640 at the central location, and a 2611 at each remote site.We are running IP only across Frame-Relay.From my station at the central site, I can ping the 3548s that are connected to the 2611s, but not the ethernet interfaces ...
I have 11 sites all tied in to the district office with 2600 routers. I would like some help on having the 7200 router route all traffice through the proxy server before it goes out to the internet...also any one know of good monitoring software I c...
