I need help with a pt project. Need someone to show me how to do it. Will pay for your time, obviously.
Forum Posts
Does anyone recognize this brand of patch panel? It was installed by a contractor a while ago and I had a need to add more jacks to it but none of the RJ45 jacks I have fit. We have jacks that fit Leviton and Panduit, but no luck with these. It lo...
I'm not getting the point of vrf In tunnel when we use # (ip vrf forwarding ivrf) and (ip vrf forwarding fvrf) ?What is the use of # tunnel vrf FVRF. ?
Hola colegas, estoy comenzando mi primer trabajo como administrador de red, y me pidieron que creara un usuario de servidor taccacs+ con privilegios solo para ver los comandos show* en la red de Cisco, pero resulta que cuando inicio sesión en la red ...
I have a strange issue that I'm having a difficult time locating the source and solution.I work for a county government. We have multiple locations but all communications go back to the Core Switch in the Admin building. The Core switch is currentl...
Hello GuysPlease may I know which MIB provides a trap definition for OID:1.3.6.1.4.1.41916.100.2 ? I have this traps generated by cisco vEdgeUnknown Specific Trap Number (114) Received for Enterprise .1.3.6.1.4.1.41916.100.237225956 VE001 S642715 VI...
Hello I was studying for 300-625 DCSAN but this certification has expired, why when replacing a certification dont have the new one ready so student who already started studying for this can still prepare to take an exam related to MDS 9000 SAN? I w...
Trying to upgrade ASR9001 from 6.2.3 to 6.7.3. DOes not have enough space on the disk. So, trying to turboboot. Any documentation for turbo boot?
Hi community, I'm currently using the Cisco packet tracer 7.2.1 0218, and I was trying to open some labs of the CCNA R&S course and I've received a message that said next "we noticed this file contained some recoverable errors and have fixed it for y...
Resolved! vrf architecture
I'm sorry if this has already been asked but does using vrf require it to be configured on every L3 device in a network? or is it 'locally significant' in the sense that as long as it properly configured on one or two routers, it’s fine. I’m trying t...
'Show run' don't show default configuration parameters, interface specific default parameters. It only shows manually entered commands only.Is there any way to find out default all hidden configuration commands and values?
IPv4: Duplicate IPv4 address 192.168.47.253 is detected on VLAN 40 with a MAC address of 3ca82a-310b00 (2 times in60 seconds). kindly provide the best solution
I've a cisco room device, which I need to add to the Control Hub. I don't have the login details, how can I get the login account
Hello everyone, i try to setup MCCA with an Squid Proxy. Unfortunately the ASA doesnt accept the Proxy as Cache Engine. ASA MCCA Config: access-list WCCP_Access remark 20230322 test WCCPaccess-list WCCP_Access extended permit ip 192.168.146.0 255.2...
Hello everyone,I'm studying the book 'CCNP and CCIE Enterprise Core encor 350-401". After reading page 411 in chapter 15 i still don't understand what 'hierarchical' means with hierarchical vrrp.What does this mean?
