HiI have a lot of AS5300 we use for serving dial up customers, each AS5300 has 4 serial interfaces , can a connect some leased line customers to these Serial interfaces? did any one try this? is there any limitation on that?
HiI have a lot of AS5300 we use for serving dial up customers, each AS5300 has 4 serial interfaces , can a connect some leased line customers to these Serial interfaces? did any one try this? is there any limitation on that?
Hi Friends !!!I have offices at three different locations in same city. At all the three building I have installed Ericcsion Digital Exchange (EPBAX) whereby my employees can get start conversation by dialing the extension only. So virtually its sing...
I've got a Cisco 2620 with NAT enabled and when I shutdown the interfaces I still cannot do a "NO ip nat pool ..... " command without it saying "%Pool natpool-1 in use, cannot destroy".What exactly do I do to remove the NAT and have straight 1-1 conn...
Anyone can help me or give me some documents?
What is the scoop on IP accounting, and what is the best way to utilize it?Thanks in advance.
two of my mail servers doing load balancing are having intermittent problem. After checking the sh cam dyn entry at the catalyst 5505, i found out that there are 2 mac entry for one of the server. I tried to reset the switch servers and even clear ma...
Hi everyone,when we have a power down on our Cat5500, all the Unix servers connected to its FE line cards reset the duplex and speed settings to 100mb half duplex stopping them working. I have to manually change the settings to full duplex, then set ...
I was wondering what is the amount of time it takes a vtp client to change it's vtp pruning mode to enable. I have just configured a new 3548xl in my vtp domain and it seemed like it took awhile to change to vtp pruning enable.
I REALLY need help understanding what products will support ISDN and analog calls at the same time on the same box. It needs to be low cost, if possible, but extremely versatile. I need a parts list and configuration breakdowns. I am desperate - afte...
Greetings,I have a small company who wants to get DSL. This what is there now. 5 computers and 5 users + one windows2000 server. They will need access from home. I thought I saw that some of the routers come with firewalls, so this is somethig th...
I have a cisco 1605 router and I am trying to configure it so that I can have snmp access to my network devices on the other side from my NMS. Can anyone help me with this?
we have 3 HP servers with 2 HP FEC enabled NIC each.The servers are connected to a switch 2912 . I'd like to know how to enable FEC on it for each server and if there are particular settings I should include thanks all
My question refers to the maximum PPS rate of the 1 giga line card
I have an AS5300 setup with 2 PRIsI have created Modem Pools for each PRI and Split the modems (48) evenly between them.The 1st PRI is setup for a propritary application using TCP_Clear and is authenticating against a Cisco Secure ACS v2.3 Unix serve...
Hello, Thanks for reading my message. I am trying to set up an 802(ISDN) router with 2 ips on the bri interface. i want one to be static mapped to an inside ip and the other to be a used for all other traffic. Can someone point me in the right...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
08-07-2024 06:15 AM | ||
07-17-2024 11:08 AM | ||
07-17-2024 06:07 AM | ||
05-29-2024 04:52 AM | ||
02-14-2024 04:00 AM |