Other Network Architecture Subjects

Is TFTPDNLD a valid option of a frame-relay network ? In other words, can ROMMON figure out how to use frame-relay to encapsulate ?I am tring to find an alternative solution to copy IOS to flash. Currently I am using xmodem to copy IOS to flash.The ...

I have two 2610 routers. RouterA in buildingA, RouterB in buildingB. RouterA has one physical serial interface with two PVC's defined: DLCI 100 (link between buildingA and buildingB) and DLCI 205 (link back to ISP for internet access). The maximum...

is it possible to set the timestamp on the 6509 to read, current time and date, rather than using "up time"? We can set the enable/disable but can we change the way it reads out?Also, how do you go about setting the throttling or setting the rate lim...

I have some problems with W2000 server with gateway Cisco router to Internet by ISDN. What i want to know is if there any chance that i program the Cisco to start making calls from 8AM and stop 8PM, for instance? How?If it can, any limitation of equi...

How frequently does topology services refresh......can the setting be changed - if so, how is this achieved?

Can anyone tell me if there ever was a compatibility issue with the PA-A3-T3 and 7206VXR? I am looking to purchase a used one and want to make sure it is compatible. I beleive the S/N of the adapter is 1788216. Thanks for any help on this.

I have a 7206 (IOS12.0(10)S) router with a Multichannel E1 card with 4 interfaces. Each has a full E1(2Mb) connection and I am trying to have those circuits load balanced using CEF configured with per-packet load balancing.The problem is that the per...

I need to change all the ip addresses of all the servers in a token ring network running Windows 2000. I know that I need to change the ip address entries in my DNS servers as well as routing tables of remote routers. Can somebody give an outline on ...

I have a client that can only get a dynamic IP from their provider with a 677 router. Can I enable port forwarding if it obtains the public IP from their DSL provider? I plan to get in using DNS2go which updates the changing public IP.Can I port fo...

Router A has two Bri-interfaces and uses Dialer interface. Router A dials up router B (isdn backup for leased line), which uses PRI/serial interface. Router B uses dialer maps. Does router A and B both have to use either dialer profiles or dialer map...

I am in the process of migrating from a single 7513 router to adding a 7206 to my data center. My boss would like me to split my frame relay lines (currently 4 T1's) between the 2 for load balancing and redundancy. I have several sites with dual conn...

I have a 2620 that has a T1 on serial 0 and then a Public network IP 63.X.X.X on Fa0/0 with a /27 subnet. My question is I want to set up a secondary IP on fa0/0 ie: 10.10.20.X. I want to use NAT for my private network with the translations from the...

We're taking several of our websites down for maintenance and we want to redirect traffic destined to those sites to a server displaying a splash page.I've implemented a route-map that redirects any www traffic from a specific source (for testing) to...

I am looking for a cost effective solution, i need a router with 4 ethernet ports. Eventually, this machine will be used in VLAN later on down the road. I have my eye on the 2600 series with the 4-Port Ethernet Network Module (NM-4E). Any advice i...

Is it possible to trunk two 10/100 Ethernet ports between the 2 standard FE ports on the 3662 Router to 2 FE ports on the 3550 Switch. If so, how?