I have a 2924 segmented into 3 vlans and on one vlan the servers no longer find any printers by IP or through network neighborhood, while the other 2 vlans are unaffected and the servers on all three vlans are humming along just fine
We have gotten a request to set up a router interface with multiple networks on a single interface, however they only want to use 1 interface IP address as to not lose an IP address in each subnet for the gateway. The user has claimed it has been do...
How can i Spilt ISDN E1 PRI channels (which is ideally 30 channels x 64kbps ) into 15 Channels x 128kbps.??? I guess bu defining time-slots ??? pls advice/guideAK
Is TFTPDNLD a valid option of a frame-relay network ? In other words, can ROMMON figure out how to use frame-relay to encapsulate ?I am tring to find an alternative solution to copy IOS to flash. Currently I am using xmodem to copy IOS to flash.The ...
I have two 2610 routers. RouterA in buildingA, RouterB in buildingB. RouterA has one physical serial interface with two PVC's defined: DLCI 100 (link between buildingA and buildingB) and DLCI 205 (link back to ISP for internet access). The maximum...
is it possible to set the timestamp on the 6509 to read, current time and date, rather than using "up time"? We can set the enable/disable but can we change the way it reads out?Also, how do you go about setting the throttling or setting the rate lim...
I have some problems with W2000 server with gateway Cisco router to Internet by ISDN. What i want to know is if there any chance that i program the Cisco to start making calls from 8AM and stop 8PM, for instance? How?If it can, any limitation of equi...
Can anyone tell me if there ever was a compatibility issue with the PA-A3-T3 and 7206VXR? I am looking to purchase a used one and want to make sure it is compatible. I beleive the S/N of the adapter is 1788216. Thanks for any help on this.
I have a 7206 (IOS12.0(10)S) router with a Multichannel E1 card with 4 interfaces. Each has a full E1(2Mb) connection and I am trying to have those circuits load balanced using CEF configured with per-packet load balancing.The problem is that the per...
I need to change all the ip addresses of all the servers in a token ring network running Windows 2000. I know that I need to change the ip address entries in my DNS servers as well as routing tables of remote routers. Can somebody give an outline on ...
I have a client that can only get a dynamic IP from their provider with a 677 router. Can I enable port forwarding if it obtains the public IP from their DSL provider? I plan to get in using DNS2go which updates the changing public IP.Can I port fo...
Router A has two Bri-interfaces and uses Dialer interface. Router A dials up router B (isdn backup for leased line), which uses PRI/serial interface. Router B uses dialer maps. Does router A and B both have to use either dialer profiles or dialer map...
