Other Network Architecture Subjects

Hello,I want to connect 5 remote pc's to my main network using one isdn line. Many differnt users are going to log onto these computers and they are going to be used at the same time. Firstly, is it possible to have all 5 machines using the same isdn...

Hi all,I have a Cisco 3662 router with 6 NM-16AM that I am using for remote access server. Recently, I have encountered two problems:1) Two of the modems will not accept incoming calls, but I can dial out from them. I have tried reseting them with th...

Will the 2611 handle 2 T1's (Full load) or will this over tax the 2611.

At my work place we have new network. Before this, everything report by user that's OK. But after new network finished, some user complain that copy and sharing, and another service become slowly and not reliable. We only enable appletalk rtmp routin...

I have 3 3640's with 2 2megs ccts on 1 router (remote end ) going to 2 3640's (host end) which each have a 2meg connected, these 2 routers are connected via ethernet. I would like to bond these 2 2megs together to form a 4m bundle,so a user on the la...

I am just curious to know if there is an Network Module (part#) that I can use to upgrade a Cisco 2610/2620 router to have more FastEthernet interfaces. Hopefully upgradable to 3! Any luck or do I have to go with the 3600 series router?Also, will t...

Is it possible to put to Router's 36XX with ATM Network modules back to back. If not what would be the best way to use a DS3

Hi, I have two switches (3524XL) configured in cluster mode (one command switch and another member switch). The vlans connected to command switch are able to communicate to core switch (6509). But vlans configured in member switch are not able to ...

Hi all; I am an ISP; Cisco strongly raccommend to use NOT CAR for aggregations greater than DS3 ... same is with Class-based policer ?I have to use rate limiting centrally with a couple of 75xx's and I'm choosing between Gigabit and ATM; what technol...

Hi!I have an unique router 7204VXR connected to 4 different routers 7204VXR throungh 4 subinterfaces in a 34 Mb serial line (E3).How can I make a backup of this line?- With another E3 and backup interface configuration, is it posible? Can they share ...

I would like to know how to ftp, from the router, to a netware based ftp server. Considering the fact that you need to provide a username and password. I am currently ftp-ing my dhcp databases from the routers to an NT Server. This command(below) wor...

We have a internet based 2600 router that I think is being access from offsite. I am wondering what the commands are to keep this from happening. I want to be only able to access the router from the console port. Is this just a simple no telent comma...

Anyone know about the capabilities of the 1751 router and it's ability to set up DMZ's? I understand that the router is modular and will allow for a second ethernet interface. Can the DMZ be set up with this one router or do I have to get another dev...

Does anyone know how to get a history of users logging into CiscoWorks? I know that you can use the "Who is Logged On" report, but that only tells you who is currently logged on. We are trying to get an idea of how many people are actually using Ci...

Being fairly new to working w/routers, I need help with accomplishing the following:The site has 25 PCs all running NT4-Wkstn and 1 server running NT4.The LAN is setup on a 192.168.xxx.xxx subnet with a domain name.Each of the PCs has a static IP for...