Other Network Architecture Subjects

My department is planning to take 4 people with no experience in LANs, and assign them the responsibilities involved to move 150 people from Ethernet to Token Ring. The 4 people will then be the on-going support to the 150 people after the LAN transi...

This should be a simple question to answer, but I can't find what I am looking in any doc. Anyway, when I do a 'copy tftp running-config', is there a way that the IOS will verify the config I am sending? If there are any errors, display the error a...

Dear Siri have 6506 switch,that is with WS-X6K-SUP1A-2GE AND TWO MODULE WS-X6348 inline power i need to implement layer 3 switching can i order msfc2 separatly or i have to order new supervisor engine with msfc2.and please provide me with the righ...

It is MANDATORY that all customers running CD One, 4th edition, install Patch 1 containing the Java plug-in 1.3.1 before January 6, 2002. Please refer to the README for all details concerning this patch.For customers using nGenius Real-Time Monitor (...

Can you authenticate users via win2k active directory without a third party software such as Radius. If you have to have third party software - does Cisco have a version to use. Thanks!

Hi, Is it possible to use same BRI interface to establish connection to two locations at the same time? One connection will be dial out and other will be dial in from another location?thanks and regards,Silju

Hi.I have a Cisco 677 router and ADSL. Need help to configure it correct for use with the following IP-range:xxx.xxx.xxx.160 - xxx.xxx.xxx.167Anyone that have implemented that with success that can help?Best regards,Lars Nielsen Lind

hi,I have a problem with the Cisco 700 Series of Routers, because some of the people in my Company, want to work home some times, we have found some Cisco 700 Routers for them, But i can't see who is dialled in to the Main Router (Cisco 2650) when i ...

How do I do an IOS upgrade for 7200 router. Also, where do I get the ios files/confg from? Thanks

I have connected one 3comnetbuilder router and one cisco2600 on serial port.But they are not pinging to each other.So what is the solution?pls help me

I want to use a network management software to managea network which has WAN and LAN.And I want to monitornetwork traffic so I can know which one is playing game or other.So who can tell me which is and how to get it?thank you for your help!

Hi, I want to connect a CAT 2924MXL-EN to a CAT 4006 with 2 uplinks. Actually I want to combine the 2 uplinks as a single data pipe by multilinking the 2 uplinks as one .. Any guidance ?Thanxkaustav

Anyone know if it is possible to perform NAT on a tunnel interface without using IPSEC? I am trying to do the following:int e0IP nat insideint tunnel0IP nat outsideAny help or ideas will be appreciated.

The standard configuration for Cisco's NAT is bi-directional (that is, it re-writes the headers in both directions). I need the ability to rewrite the source headers on outgoing packets, but not the destination headers on the return of the same IP s...

I have mistakenly erased the NVROM and flash on this switch. I located the software for this switch on this site, but I'm unable to load it. Any suggestion are greatly appreciated. Thanks.