Other Network Architecture Subjects

Hi i am having a problem with my 803 series router i have a cable modem that i gain internet access from i want to connect my router to the cable modem and my pc to gain access to the internet throught the router i also want all my other machines to ...

HiI have a Cisco 2600 that needs to be implemented in a LAB. How would I go about simulating a 64K link over a 100 Mb fastethernet port ? Is the rate-limit command the correct way ? Thanks

Hello,Is it possible to rate-limit per VLAN with the Layer 3 Module on a Catalyst 4006? If so, is all traffic passed through the CPU and how much rate-limited traffic is too much to handle?thanks,Mike

port mirror is needed in my case,but cisco website told me 2948G-L3 doesn't support it?is it true?do anyone have any other ways to solve it?Thanks,Davy

Hi all,I am relatively new to the cisco world and have installed a switch that seems to funtionally work ok. However, after setting up the config I am finding that all ports on all modules display an 'inactive' under the port status column. I've trie...

At present we are using Intel Switches Intel Express 550T to connect between 2 buildings. VLANs have been created but they only support 100MB. I have been looking to replace them with Cisco Switches but unable to obtain any sufficient info on the Cat...

How it works ? Can I think it as a time-division model?Thank you!

I'd like to add gigabit ports to my 5500 (WS-C5500) with Supervisor Engine III module (WS-X5530-E3).I've read through sheets on the WS-X5410 but I'm not sure whether that interacts directly with the backplane, or if I need to add a GBIC module to my ...

HiI have one 6 M serial link and I want to reserv 1M for several IP's. 1M quarented bandwith if the link is full but in case if the link is not full this IP's to can consume more bandwith.Which tehnique muss I use ?Can somebody give me some tips or h...

Greetings........Imagine a network of 3 routers;x,y,z connected in a triangle kind of a mesh. X Y ZX connected to Y connected to Z connected to X back again.What i hope to know is ; is...

HiI have routers (2621 and 3640) with VWIC-2MFT-G703 modules. Are these modules capable for DropInsert ?Thanks

I connect to my office test router through telnet. To overcome session timeout problem I changed the absolute-timeout to 480 minutes, not realizing that it will disable telnet connectivity after 480 min. Now I can not connect to my router. I will app...

Friends,I have a customer who is experiencing some packet loss problems. I logged into his router and did some testing. When I ping the WAN far-end, I have 100% success. However, if I try an extended ping, I miss every other ping (!.!.!.!). I already...

We are in the process of converting our wan protocol to BGP. Our "spoke" centers are running Cisco 2500/2600s and in some cases 4700s. What is the most suitable version of the IOS that we should use? thanks.

Can someone tell me where I find document aboutmanagement image software of Catalyst 8540?And what is the FPGA software? Is it the rommon ?(upgrade and so on)ThanksLorenzo