Other Network Architecture Subjects

I'm preparing to retake my CCNP Switching test right now and I ran across something in my reading that has me stumped.It has to do with the designated port.Lets say there are two switches, switch A and switch B. Switch A is the root bridge. Lets al...

I'm trying to find an easy example of how to limit the amount of bandwidth two certain ports on my 4507R switch can use at any given time.I have two servers connected to these portsthat I want to limit the bandwidth to 2mbsand leave the remaining bad...

Wheh i put ip cache flow in my router , i saw that lot of traffic going towards the interface NULL 0 what it means 1) Is it the virus traffics 2)if not how this traffic is generated

is it possible for me to find out the actual speed of the link connected to my serial interface on the switch ? does it auto detect it ?

hallois there a way to know if a cisco catalyst switch is working in store-and-forward, fragmentfree or cut-through ?Can we change with ios the switching mode ?regardsfrancesco

I read many articles in Cisco webpage that i can make etherchnnel between normal ports in two switches catalyst.Can I make an Etherchannel using two uplink ports on a Catalyst 2950T and two normal ports on a Catalyst 2960G?. Thanks

Hi Expert,How can I limited the route from advertised to a neigbhor?The network setup is as follow:Subnet A - Router A -- Router B - Subnet BSubnet CRouter A have subnet A and CRouter B have subnet B.I want to stop router A advertised subnet C to ...

I am experiencing the following problem at a client site any suggestion on how to resolve this problem would be greatly appreciated.The client has got 2 Cat6509 core switches, there is a cat4507R with a Sup4 hanging off these two core switche...

If I have 2 dialler interfaces, and 1 BRI interface, can i just put them both in dialler pool 1, or do I need to have 2 different pools for the dialler interfaces, and then put the bri as members of both ?

I am to try to redirect port 3500 of dialer0 for an IP 192.168.1.2 in the Lan whit the same port number. Already I moved in nat. E I created rules ACL. But I did not obtain.Router cisco 836 My config:!no service padservice timestamps debug datetim...

i have got 1 3750 L3, having vlans mentioned below.2 Routers 1700 series(main center) connected to the 3750, 2 other routers connected on the remote location which is connected in the main center routers.few machines are in vlan 3.Main Center Routers...

Does anyone know how to clear out the configuration buffers on a 800 series router (other than a reload)?error:router#wr memBuilding configuration...% Configuration buffer full, can't add command: 10.10.10.10%Aborting Save. Compress the config, Save ...

Sir,If I have no BRI port and I want to connect internet through ISDN line then what we will do ?