Other Network Architecture Subjects

Hi,What can be the reason of the crash?%Software-forced reload Breakpoint exception, CPU signal 23, PC = 0x6054EF18-Traceback= 0x6054EF18 0x6054CD54 0x601EBB60 0x601F1850 0x629BA354 0x6021672C 0x6020CDCC $0 : 00000000, AT : 64460000, v0 : 646A0000, v...

A remote router is in rommon - I can't use xmodem as there is not enough space to load the image to, so I need to know how to delete flash from rommon mode.

Dear Sirs, Please teach something to the connector of the AC power supply of "PWR600-AC-RPS-xxx".Best regards,

H,I'm getting the following error while try to save the configuration in L3 switch.Rou#wrBuilding configuration...% Warning: Saving this config to nvram may corrupt any network management or security files stored at the end of nvram.Continue? [no]:wh...

My Linksys Cable/DSL Router doesn't work. In the middle of the wizard setup an error appears saying the router can't connect to the internet. I can access the internet without the router.

Hi!Very high utilization upto 99% is being experienced on a cisco 4506 switch. I have not been able to acertain the cause for the same. Although I have noticed that 2 particular interfaces(both running on a speed of 100Mbps) of which 1 is connected t...

Greetings. I just unwrapped my new Cisco 831 router, and everything worked out of the box (my post in this newsgroup is proof). However, when I attempt to access the CRWS web setup utility, I get a "Please wait while we check router version, IOS ve...

I have a 1601R router considering that the router has reached its “end of life” for support and software upgrade it has been suggested that I replace the router with an 1841. I am currently running ISO 12.0. From what I understand I can upgrade to ...

Hi NetPro,does anyone knows have any idea about the HP Server, this server(HP Server 380G4 ILO), still keep err-disabled in Cat 4006 switchport, eventhought i have put the "errdisable recovery cause all" , the err-disabled still keeping up. any idea ...

I'm trying to hang an unmanaged switch (netgear FS108)off this switch but with little success. I've configured the port on the Express 500 as a switch port but nodes connecting through the unmanaged switch can't fully browse nor can they receive DHCP...

got the router the day before I left on a trip and started to configure it. well fast forward two weeks and I'm back and I forgot what the IP address was, I tried all the addresses I though I would of used but still can't connect. Is there a way to...

I have a 6500 with an sc0 interface that is addressed with a 77.x.x.x address. Is this an internal Cisco thing (similar to how Microsoft has the auto address of 169.254.x.x)?? Thanks!!

Static routes are added.both network pcs are able to access oracle server.Internet facility is available only in router A network , router B network pcs are not able to browse internet. mask has changed to 255.255.0.0 and checked, also add route has ...

Hi,Does anyone know what is the number of DHCP pools supported by IOS DHCP server? How many pools can be configured? I'd like to implement a centralized DHCP service to an existing customer network so that their main site CPE would act as a DHCP serv...