Other Network Architecture Subjects

I have 2 Cisco 4506 running HSRP with each device having a separate routed link to our main office. one issue that i am having is if i disconnect one of the routed link to our main office from one of the 4506, all end devices that are connected to t...

Hello All,At the present time our Cisco Pix redirects all outgoing internet traffic to our WebSense proxy service for internet filtering. Now, we are moving to a packet sniffing filtering solution (i:filter) and do not want that traffic going to the ...

hi... there is somebody to explain me the difference between:ip route 0.0.0.0 0.0.0.0 <next_hop>andip default-network x.x.x.x?thanks

Dear All,I would like to know more about Flow-Control on Ethernet copper and Gigainterface as we are planning to enable it, based on recommendation from one of our Netapps(storage device) consultant as they have enable it from their side and now the...

Hi All, My question is that I would like to know if I 'clear ip route' on an EIGRP environment which would clear the IP routing table,would the EIGRP neighbor relationship be lost ? This is because since the IP routing table is cleared, then c...

Hi Guys,I have implemented STP onto our l2 network - I now want to force a switch within the loop to use another path as apposed to the one selected by STP. I have configured the Port-priority with my prefered int having a higher priority but the swi...

Hi,Since short I receive the following message once and a while.Jun 29 09:03:27.459 CEDT: %SCP-4-DACK_TIMEOUT_MSG: SCP delivery ack timeout for opcode=11DJun 29 09:09:49.510 CEDT: %SCP-4-DACK_TIMEOUT_MSG: SCP delivery ack timeout for opcode=11DAccor...

Can anybody confirm if we really need to specify the speed under a Gigabit interface (ws-x6748-tx) if we want to activate the Storm-Control feature. Without the speed fixed we received sometime the following message :"need speed to config thisro_rtp_...

hii don't understand what is the meaning of Permanent Virtual Circuit, & Switched VC . and the differnce between them, if u can explain me, i will thanks u a lot

hello my friendsi would like to ask what this command means ? and when i need that?(about eigrp)thank u

i would like to know how much bandwidth it's take to transfer on the lan the follow subject:snmp getsnmp setios versionios upgrateset configurationThe question is about 2811 routerthnks you.

Ok, I thought I had the reason for the VLAN interface command down. I thought it was either used for switch management or routing between VLANS? However, now I realized that some communication wont work with out this command which doesnt make sense...

I have several buildings with fiber transceivers between them, can I implement 802.1q trunks between my catalyst 3550s? Currently these are access ports. There are no gbics slots available to use the WS-G5484, thus I am using the transceivers.