Other Network Architecture Subjects

I have configured Ciscoworks LAN Management Solution 2.2, and my ATA's have become discovered.Can i configure Ciscoworks to be able to monitor them, my Callmanagers are now communicating, and are visible on Topology View, (i can interogate them)How d...

I have couple 2501 routers (10mbps ethernet) I would like to configure for vlan routing. However, because the ethenet interface is only 10mbps the option is not available. Do you know if Cisco has an IOS that will allow me to use the 10 mbps interf...

I am trying to configure a WIC-4ESW WIC in a Cisco 1760. I have the proper image which recongnizes the card. What do I have to do just to have the 4 FE ports to perform basic operations. I can't get the F1/1 interface to be recongized.

I have a 7206vxr router connected w/ two BGP peers. I'd like to do a traceroute BUT put a condition on it. Say - traceroute <route_ip> <exit via bgp peer x>If this is possible w/ changing any BGP parameters (meds or ASN path lengths) or implementin...

How can I broadcast a packet in such a way that it can cross the routers?

Hi,When manually adding devices to RME, I get some devices come up in "Not Responding" with the following status error: "could not commit groups and annotations".Does anyone know what this means and why it happens?Thanks.

Can you telnet to a router that sits behind a NAT device? I've got a home lab sitting behind a D-link NAT device. I can open port 23 and direct it to the interface of the router, but get time-out errors when trying to telnet.

I have 2 3660 in 2 locations, the locations are connected by a t1 and a t3, running eigrp. I want certain subnets to ride the t1 by defualt, and only ride the t3 in the event of the t1 going down.for example,3660A 3660B...

running campus manager 3.3. my 3550 show up as ciscoprodusts.485. 3550's are running IOS (tm) C3550 Software (C3550-I5Q3L2-M), Version 12.1(13)EA1a. WS-C3550-24-PWR (PowerPC) processor (revision D0)my 6513's, 4503's and 3550-12g's show up fine

I have a small network with an app server that we connect to using internal IP (192.168.20.xx) using DSL. After switching to a Frame Relay type of service with the new (TCP/IP) configuration (IP, DNS, Subnet Mask), my internet of course is faster but...

I have a 2822 switch that won't accept upgrades to 9.x Enterprise firmware (or anything close to it, Enterprise or not). It has 5.something on it and I can load that image as many times as I want to, but nothing newer.It's not a memory limitation, as...

Is possible to create an etherchannel between 2 GBIC interfaces of a Catalyst 4506 in one side and two GBIC interfaces of two different Catalyst 6000 chassis inthe other side?.

When will the 3550 support the 802.3af PoE standard?