Other Security Subjects

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 

Forum Posts

Hello,I am integrating a remote site in to our enterprise network, which involves removing an existing firewall and replacing it with a Cisco ISR DMVPN router.At most sites, I've been using a fairly basic IOS firewall configuration, but this site has...

d.parks by Level 1
  • 327 Views
  • 1 replies
  • 0 Helpful votes

I was curious if there was any way to get policy updates easily to clients who may not come into an office frequently if at all and may not VPN in. We are looking at deploying CSA, but have users that don't VPN in because of RPC over HTTPS for email...

Hi,I'm after some feedback on the following configuration.On an ASA 5520 we have 3 different zones each on separate interfaces and different VLANs. If these were all connected to the same 6504 switch along with the servers would this present a securi...

alitster by Level 1
  • 359 Views
  • 2 replies
  • 0 Helpful votes

Hi allAM installing a guest network for a large hotel, 200 wired points and a 30 access points. This network is physically separate from the hotel network, however there is a firewall that connects to the internet that does nating.Since this is a gue...

While there is no migration path to CSA 5.1, it is conceivable to build from scratch, re-write rules, and redeploy the new agent.Has anyone tried this? I?m looking for success and horror stories. My biggest fear is the redeploy of the agent ? I assum...

ronnemeth by Level 1
  • 825 Views
  • 9 replies
  • 0 Helpful votes

I am using the Microsoft L2TP/IPSEC VPN client using preshared keys connecting to a Cisco 3020 with IAS as my authentication. I can establish the sessions with no problems and access what I need to. However when I try to send the Class attribute 25 b...

I have a requirement to give static NAT ip addresses to some Video Conference equipment. The issue is that the equipment floats within the building so it could be hooked up to any number of vlans at one time (one at a time of course) but for Outsour...

jfowler by Level 1
  • 915 Views
  • 3 replies
  • 0 Helpful votes

Resolved! Logging Commands

If I don't have "aaa accounting commands" configured, will I still be able to capture all commands entered if I have my logging traps set to debugging? i.e., what is the significant difference between the two? Don't both methods achieve the same ob...

archie_25 by Level 1
  • 453 Views
  • 2 replies
  • 0 Helpful votes
Top Solution Authors