Routers - Small Business

I recently upgraded from 1.0.1.3 to 1.0.2.6. I tried to change on of my port VLANs and couldn't find the port vlan configuration anymore. After a lot of searching, I reloaded 1.0.1.3, reconfigured the port vlans and then reloaded 1.0.2.6. All is fine...

I am trying to create a simple 2-VLAN configuration on an RV110W.  After adding the VLANs, I am unsure how to specify whether the port traffic should be tagged, untagged or excluded.On the VLAN Membership page, I want VLAN 3 associated with ports 1,2...

Currently on V1.3.0.5. Looking to upgrade to latest version, however the upgrade firmware page is greyed out. Same under Firefox 9 or IE 8. I have already rebooted router, with no change in behavior.

Periodically during the day, my RV220W stops routing all traffic.  Nothing between devices on the network nor between internal network and the Internet.Anyone else expriencing similar behaviour?Currently on firmware 1.0.2.4 after version 1.0.3.5 exac...

I've just purchased WRVS4400N VPN router and installed it. This was a replacement of a old Linksys router. After installing the router, I've started seeing wireless drops, packet drops and latency on pings. I've installed the latest firmware, disable...

Hi,i've recently tried to enable IPv6 but since then, the router has gone wild.A few minutes after reboot it starts to send "malformed IPv6" packages (according to wireshark), stops responding to DHCPv6 solicitations, forwards packets just to a very ...

HiIs there a roadmap for the uc500 ?If the answer is positive, do we have an approximative date ?RegardsPhilippe

HiIs there a roadmap for the uc500 ?Is there a plan to support the 89441 and 8945 ?If the answer is positive, do we have an approximative date ?I read this document, at this date it is not supportedhttp://www.cisco.com/en/US/partner/prod/collateral/v...

I put just got a wrvs 4400N and when I replaced my old linksys router I can't access my network computers anymore.  I'm I missing something or do I need to do some kind of setup?

Hello, I am currently accessing the internet on my home lan with a Linksys wrt54g dd-wrt in bridged client mode (small town wifi to T1 network) with a static IP, but plan to add an additional WildBlue 12mbps satellite connection. What I’d like to do...

The RV082 is a great unit, however when VPN clients connect the QuickVPN Client has a setting to use the Remote DNS settings of the RV082. The RV082 has no way of linking or using a user-defined DNS. I have an internal DNS Server that I would like th...

At this moment (firmware 1.0.3.5) the router has no IPv6 firewall and therefore when used in a typical dual stack IPv4/IPv6 network it has no protection regarding IPv6 traffic. Hopefully this will be fixed with a firmware update before the World IPv6...

Hi,at our office we have a brand new WRVS4400N with 2.0.1.3 fw preinstalled.In order to make a VPN connection to our cliente, we need to establish an IPSEC VPN with AES-CBC encryption, but in the drop-down list I can only select 3DES.Does v2.0.2.1 fw...