HelloI am trying to configure my Cisco 4221/K9 and when I enter a command in the privileged mode it say the configuration is not supported. It has a linux terminal when I click the question mark in this case to finish my command like config terminal ...
Hi Everyone, I’m currently in a bit of hurry to implement a traffic manipulation for a new client. we currently have bgp session with 2 ISP and we are advertising all our prefixes to both as we are running load balancing. the new client wants their ...
I would like to configure kron policy and occurrence but my router requires an "enable password". what is the command to achieve that?
I kindly help or documentation on how to reset cisco catalyst 8300. Please any guidance or document ?
I have forgotten the password for the PT Activity Wizard. Could someone please help me out? Thanks,Brian
Hello,just wanted know the below mention error on Cisco -4331 router%CRYPTO_ENGINE-4-CSDL_COMPLIANCE_RSA_WEAK_KEYS: RSA keypair Is there a cause and solution?
I am learning to configure vlan but after I configured it, the connection between PCs was not connected.Please help to solve it
HI all.I want to use IP SLA source-interface as Loopback 0 R1's config ip sla 1icmp-echo 2.2.2.2 source-interface loopback 0 !ip sla schedule 1 life forever start now!track 1 ip sla 1 reachability !ip route 2.2.2.2 255.255.255.255 192.168.1.2 trac...
we have 2 Cisco L3 switches and each having one uplink. Customer want to configured OSPF and static routing both for redundancy purpose at route level. So my question is that if any case OSPF goes down than traffic will diverted on Static route or no...
hello guys,Newbie here. I have been trying static routing for my lab and I'm unable to establish communication b/w computers connected to different routers. i have established routes for both the routers and they are showing up in the routing table b...
Hi TeamI am facing some issue in my topology where i configured ospf over a 2 port lacp link in the cpe router and i want loadbalance(dl/ul) on both of the link but the ospf is working as failover mechanism, and i am not able to balance traffic on bo...
Hi, i have Router Model:- CISCO4221/K9 V04Based on initial check, contract/ subscription ID already Overdue. Expiry date on 8th June 2023. Support still available until 30th Nov 2028. Info based on Cisco CCW-R. Please advise what should i do.
Can someone help me finding appropriate answer to the question in attached snapshot.which one would be correct option 1) network 172.16.0.0 0.15.255.2552) network 128.0.0.0 127.255.255.255
We have ospf set on a leaf 101 ( DC1) to legacy router at DC2 , we want to have static route for specific host to remote side , I see that is done from the existing ospf L3out --noide profile leaf 101 and add static route ,the static route will take...
I was trying to configure CEF on gns3. The above are tow screenshots of the lab.From the debug output above we can see the ICMP packet is routed via FIB.The FIB and adjacency tables are used by CEF to forward packets in hardware.But the command sh i...
